A list of all things that could make a L-Jet Jerky, now with ............Pics of my troubled head Options

[jsayre914]

I have a great daily driver. 1.8 L motor with L-jet injection, and it jerks like a son of a %^$%. It has all new vacume lines, none of wich are leaking (idles smooth at 900rpm) i have blocked off the deceleration valve. It was not letting the idle come back down fast enough for my taste. New jugs rings pistons etc. It has new plugs and wires. a new resistor pack and a newer duel relay. new alternator and new voltage regulator. Valves adjusted .006/ .008 perfectly with new valve cover gaskets. It has a new fuel pump and fuel filter, and many new wiring harness. Injectors were all cleaned and new screens put in. It runs up to 5K with no problems and runs strong to about 110mph on a flat. (IMG:style_emoticons/default/driving.gif)


Whe i accelerate easy it starts to jerk the whole way. If i try to run in 2nd or 3rd it jerks the whole time even at constant speed. sometimes i will seesaw the clutch just so i dont look to embarrising.

What is the list of things to check (i want to check everything) but i feel like i checked it all and then rechecked it (IMG:style_emoticons/default/confused24.gif)


one other problem probably related, i cant keep constant power to the fuel pump through the relay, it chokes off sometimes and dosnt want to come back (PITA) so i jumped the fuel pump lead to the + coil for now. (dont be mad) (IMG:style_emoticons/default/rolleyes.gif)

[r_towle]

Check the advance plates on the distributor and the little ground wire.

Capn Krusty had a few new ones on the shelf, and George at AA also has new ones on the shelf.

Also the vacuum advance canister on the distributor can contribute to the problem...pull it off of the advance plates, remove it from the distributor and cap the vacuum line...the car will run fine without it for testing purposes...


Those issues do create a jerky car.
First I would replace the gaskets on the oil filler cap, there are three...a o-ring in the lid, a gasket in the lid, and the gasket under the base of the filler assembly.

Rich