 Location of #1 spark plug wire on distributor, Distributor for a 2.0l stock FI engine |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| watsonrx13 |
 Feb 26 2010, 05:16 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 2,735 Joined: 18-February 03 From: Plant City, FL Member No.: 312 Region Association: South East States  |
Do I have the arrow on the #1 spark plug wire? This is a distributor for a 2.0l stock FI engine.
 --Rob |
   |
 
|
  |
Replies
| Gint |
Feb 27 2010, 09:14 AM
Post
#2
|
|
Mike Ginter Group: Admin Posts: 16,084 Joined: 26-December 02 From: Denver CO. Member No.: 20 Region Association: Rocky Mountains  |
Distributor drive gear from the factory manual:
Installation The following points must be observed: 1 - Check helical teeth of ignition distributor drive shaft for wear. If wear of helical teeth is excessive, be sure to check teeth of ignition distributor drive gear. 2 - Check wahers under ignition distributor drive shaft for wear; use new washers, if required. 3 - Adjust cylinder 1 to firing point. At that moment, the exhaust valve on cylinder 3 will close and the inlet valve will begin to open. 4 - Install ignition distributor drive shaft.The offset slot in the top end of the distributor drive shaft should be at an angle of approx 12 degrees (the picture in the manual show this 12 degrees to be pointing left of center line of engine) in relation to the longitudinal axis of the engine; the smaller sector faces towards vehicle outside. 5 - Install spacing spring. When installing the distributor shaft in 1.8 liter engines, beginning with 1974 models, use the 7.S” mark instead of the indicated TDC mark. 2.4-3/2 RemovaI and Installation of Ignition Distributor Drive Shaft |
|
|
|
Posts in this topic
watsonrx13 Location of #1 spark plug wire on distributor Feb 26 2010, 05:16 PM
dr914@autoatlanta.com
Do I have the arrow on the #1 spark plug wire? T... Feb 26 2010, 05:34 PM watsonrx13 So the #1 is on the other side of the vacuum advan... Feb 27 2010, 06:14 AM type47 I see the answer as highly dependent on if the dis... Feb 27 2010, 07:31 AM
watsonrx13
I see the answer as highly dependent on if the di... Feb 27 2010, 07:38 AM type47 Putting the drive gear in correctly is pretty easy... Feb 27 2010, 07:55 AM Gint There is a picture and description of indexing the... Feb 27 2010, 09:04 AM ArtechnikA IIRC there is an index mark on the dizzy body. To... Feb 28 2010, 05:45 AM type47
I'm used to seeing this on Bosch distributors... Feb 28 2010, 07:42 AM watsonrx13
I'm used to seeing this on Bosch distributor... Feb 28 2010, 05:58 PM Cap'n Krusty
I'm used to seeing this on Bosch distributor... Mar 25 2010, 01:47 PM ArtechnikA
Why would you bring the engine to TDC for valve a... Mar 25 2010, 01:53 PM rdauenhauer So Ill chime in here as yesterday was a glorious s... Mar 25 2010, 10:19 AM ArtechnikA these are 'is it plugged in' questions.
Go... Mar 25 2010, 11:42 AM rdauenhauer yea Ive gone way outta my way to keep it ALL origi... Mar 25 2010, 11:54 AM thompson-mfr These pics are from a '74 2.0
This proble... Mar 25 2010, 12:23 PM vsg914 You can clearly see the index mark on Thompsons po... Mar 25 2010, 01:21 PM ArtechnikA
If the diz fires at 27degrees before top dead cen... Mar 25 2010, 01:27 PM |
5 User(s) are reading this topic (5 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 21st June 2024 - 02:36 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.