Electrical Problem / Insanity, Starter issue Options

[jsaum]

Before I go totally insane I'm hoping someone can help me through trouble shooting a problem with the ignition switch not actuating the starter. First a little information, I have a late model year 1972 1.7 with the fuel injection removed and a carburetor installed. After six months of working on the car I've finally gotten to the point where I have installed the motor with a new starter The car has been apart for 12 years sitting in the garage. First the starter failed to work when I tried to turn it over. Thinking the new starter was bad I took it off and had it tested this morning at the auto parts store it works fine. I also had the battery checked and it is good as well.

I put the starter back in and it worked four or five times so I thought it was fixed. I then hooked up the fuel line and went to try and start it and the starter wouldn't work again!#@%###. I can jump it across the positive battery cable to the solenoid and it works. I have 12 volts on the yellow wire to the started solenoid when it is disconnected and 8.5 volts when it is connected when the key is turned. I have checked the relay board at pin # 6 and I have 12 volts there when the key is turned with the connector off. I ran a jumper wire to the solenoid from pin# 6 on the relay board and the voltage goes down to 8.5 when the key is turned to start so I think I have eliminated that the yellow wire is bad from the relay board to the starter solenoid.

I can't tell from the schematic my manual if there are other things in the circuit I should check. I'm wondering if my ignition switch is bad.

Anyone have any ideas or insight? Any suggestions or directions would be gratefully appreciated.

Thanks,
Jsaum

[drive-ability]

If my car did this I would opperate the starter from the solenoid, feed it with power off a battery positive source. That will narrow down some things. If it works good then its likely the major inputs and grounds are fine. If not then you need to make sure battery voltage is up and the major power inputs are good. That list would include the battery grounds on both ends and the positive cable at both ends. I would say the starter is always something to look at as well.
The most important part is you, if you can evaluate good things from bad things (IMG:style_emoticons/default/biggrin.gif) If not all bets are off.. (IMG:style_emoticons/default/wacko.gif)