 Sheet metal mods for 3.6 conversion, cut and paste 101 |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| East coaster |
 Mar 30 2004, 09:19 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,793 Joined: 28-March 03 From: Millville, NJ Member No.: 487 Region Association: None 
 |
Finished my sheet metal mods to fit the 914-6 cooling tin to the 3.6 engine yesterday. I figured I'd post some pics so if someone else has to cross this bridge it'll give them some ideas. Since you can't buy a kit that fits the 3.6 you need to do something like this...........
Attached File(s) |
   |
 
|
  |
Replies
| Brad Roberts |
Mar 30 2004, 11:25 PM
Post
#2
|
|
914 Freak! Group: Members Posts: 19,148 Joined: 23-December 02 Member No.: 8 Region Association: None |
Tidbit of info on the block off plate for the fan shroud:
Drill holes in it and let it breath a little. The fan was setup with a certain back pressure on it, you change this when you block that area off completely. Dyno pulls and testing showed a reduction in cooling. Dont ask me how. We where all standing there scratching our heads (Jerry Woods dyno) We vent all of them. Your tin looks awesome. B |
|
|
|
Posts in this topic
East coaster Sheet metal mods for 3.6 conversion Mar 30 2004, 09:19 PM
East coaster next pic....... Mar 30 2004, 09:20 PM East coaster ........... Mar 30 2004, 09:20 PM East coaster rear....... Mar 30 2004, 09:21 PM East coaster again.... Mar 30 2004, 09:22 PM East coaster distributor area... Mar 30 2004, 09:22 PM East coaster These shots highlight the areas (in red) where you... Mar 30 2004, 09:24 PM East coaster This is where the factory 6 oil cooler resides, th... Mar 30 2004, 09:26 PM East coaster had to add plate behind the dizzy. The cam shaft c... Mar 30 2004, 09:27 PM East coaster Last but not least, a block off for the factory he... Mar 30 2004, 09:30 PM East coaster Oh yeah..........cut and fit the oil tank holes th... Mar 30 2004, 09:32 PM Jeroen Very clean job!!!
cheers,
Jeroen Mar 31 2004, 03:51 AM RON S. Great looking job Easter.
All the trial and er... Mar 31 2004, 06:10 AM JmuRiz Wow, that does look nice. In the first pics you c... Mar 31 2004, 08:22 AM
East coaster Brad/Ron, Thanks for the feedback! I guess I... Mar 31 2004, 08:30 AM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 10:00 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.