 new carb issue - i think |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| william1764 |
 Mar 5 2011, 10:29 AM
Post
#1
|
|
Member  Group: Members Posts: 252 Joined: 11-May 10 From: maryland Member No.: 11,717 Region Association: MidAtlantic Region  |
Finally corrected the serious backfire issue i had (IMG:style_emoticons/default/cheer.gif) exhaust leak was found (crack at header mount flange area) and repaired...long story but excessive/loud backfire on decel has been FINALLY eliminated. Overnight however i developed a sputtering/popping thru carbs. Uneven and rough acceleration up thru 3k RPM and higher. idle is irregular but constant - either a little high or a little low but steady...varies on the day. I have noticed since the carbs were rebuilt last september fuel mixture out of the exhaust at startup...i assume too rich? new plugs already dark. i've only put on a couple hundered miles since carb rebuild so not much experiance since rebuild.
what could happen to cause the engine/carbs to take such a drastic turn from one day to the next with touching them? Could this be valve issue? for those not familar with past issues my set up is 74 2.0 with weber dual IDF 40's. on another note, anyone in balt/dc going to hershey? |
   |
 
|
  |
Replies
| william1764 |
Mar 5 2011, 12:21 PM
Post
#2
|
|
Member Group: Members Posts: 252 Joined: 11-May 10 From: maryland Member No.: 11,717 Region Association: MidAtlantic Region |
I'll try the above and post results. Thanks gents
|
|
|
|
Posts in this topic
william1764 new carb issue - i think Mar 5 2011, 10:29 AM
NJ914Guy Have you checked the wires, cap and rotor? Also i... Mar 5 2011, 10:33 AM BarberDave :trophy:
Check the idle jets, easy to remove j... Mar 5 2011, 11:01 AM Vacca Rabite You may be jetted a bit rich and fouling plugs.
Do... Mar 5 2011, 05:27 PM
william1764
You may be jetted a bit rich and fouling plugs.
D... Mar 6 2011, 07:40 AM jmill I'd check the idle jets first as already menti... Mar 5 2011, 09:42 PM william1764
I'd check the idle jets first as already ment... Mar 6 2011, 07:43 AM seebobgo
I'd check the idle jets first as already men... Mar 6 2011, 12:00 PM jmill
is there an easy way to tell if linkage out of ad... Mar 6 2011, 02:20 PM seebobgo
is there an easy way to tell if linkage out of a... Mar 6 2011, 02:32 PM william1764
is there an easy way to tell if linkage out of a... Mar 6 2011, 07:14 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 07:47 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.