 Ball Joint Nut Removal |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| dralf |
 Apr 9 2004, 05:55 AM
Post
#1
|
|
Member  Group: Members Posts: 230 Joined: 24-January 04 From: Dayton, Oh Member No.: 1,597  |
Help,
I am still taking my front end apart and have stumbled onto ball joint nuts that refuse to budge. I have soaked them in penetrating oil and have been attacking them with the socket type tool sold by Pelican Parts and a 5 foot cheater bar. No luck ! I am actually starting to deform the prongs or teeth that interlock between the tool and the nut. I am reluctant to use a torch for there is so much grease and oil in that area that I will have a 3 alarm blaze...my only thought is to some how cut or split the nut since I will be replacing the ball joints anyway (IMG:style_emoticons/default/sawzall-smiley.gif) I started that mode of attack last night both with a drill and a hand hacksaw but I was not making nuch progess, the nut must be harder than my tools. Any sugestions would be greatly appreciated. |
   |
 
|
  |
Replies
| rhodyguy |
Apr 9 2004, 09:48 AM
Post
#2
|
|
Chimp Sanctuary NW. Check it out. Group: Members Posts: 22,193 Joined: 2-March 03 From: Orion's Bell. The BELL! Member No.: 378 Region Association: Galt's Gulch |
|
|
|
|
Posts in this topic
dralf Ball Joint Nut Removal Apr 9 2004, 05:55 AM
Eric_Shea You have the P210 tool it sounds like. There... Apr 9 2004, 06:12 AM joea9146 I used a Dremel with the cutoff wheel cut 2 or 3 s... Apr 9 2004, 06:13 AM ArtechnikA make sure you're using -good- penetrating oil.... Apr 9 2004, 07:07 AM John2kx Had similar problems getting mine off and used a 2... Apr 9 2004, 07:20 AM SpecialK Yep, pipe wrench and 18" of 1" black pipe (cheater... Apr 9 2004, 10:51 AM
dralf Thanks for all the hints and advice..
I am borrowi... Apr 9 2004, 12:49 PM |
4 User(s) are reading this topic (4 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 21st December 2024 - 11:10 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.