 JOE's Hershey Emergency Thread, oooohhhhhh nnnoooooooo |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jsayre914 |
  Apr 22 2011, 05:21 PM
Post
#1
|
|
Speed Up !!!  Group: Members Posts: 3,206 Joined: 10-February 08 From: Timonium MD 21093 Member No.: 8,696 Region Association: MidAtlantic Region  |
(IMG:style_emoticons/default/sad.gif)
Just about 30 min ago i got stuck in traffic on 83, there was an accident. I was in stop and go for about 10-15min. My car has been making a noise kinda like a compression ticking sound from the drivers side. But today it really started acting funny. The idle was dropping in and out in traffic, and when i went to move foreward each time... the car was shaking (violent) like it was running on 2 cylindrs. I kept revving it up to keep it smoothed out. When i got out of the jam, it seemed to come back once i got up to speed, but again when i hit a red light. I am at work right now so i cant actually trouble shoot. I did pull each wire of the plugs and it did not stumble on the drivers side rear plug. It did however stumble when i pulled the injector wire off the same cylnder (IMG:style_emoticons/default/WTF.gif) Valves were just adjusted last week. I WILL MAKE IT TO THE EVENT !! any advise would be greatly appreaciated. p.s. Its raining (IMG:style_emoticons/default/dry.gif) |
   |
 
|
  |
Replies
| jsayre914 |
Apr 27 2011, 01:08 PM
Post
#2
|
|
Speed Up !!! Group: Members Posts: 3,206 Joined: 10-February 08 From: Timonium MD 21093 Member No.: 8,696 Region Association: MidAtlantic Region |
I started to drop the engine last night, but then both of my girls started (IMG:style_emoticons/default/barf.gif) (IMG:style_emoticons/default/barf.gif) all evening and this morning (IMG:style_emoticons/default/sad.gif)
I got about 3 hours sleep. If everyone is feeling better tonight I will continue. in about 1 hour I got this far car jacked up wheels off cvs off shift linkage unhooked muffler/heats off throttle cable off speedo cable off clutch cable off fuelpump lead unhooked voltage regu lead unhooked engine harness unhooked batteries unhooked pretty sure all i have left is... ground strap fuel lines unbolt and go Next question, what exactly should i be looking for on the head/ or valves. (dont worry I will post pics) |
|
|
|
Posts in this topic
jsayre914 JOE's Hershey Emergency Thread Apr 22 2011, 05:21 PM
vsg914 If you still have points, check dwell and timng. H... Apr 22 2011, 05:43 PM sww914 Sounds exactly like a bad spark plug wire to me. Apr 22 2011, 05:44 PM jsayre914 its got pertronix.
1.8 liter with L-jet
the wire ... Apr 22 2011, 05:47 PM Gint Could be a lot of things, but it sounds like ignit... Apr 22 2011, 07:19 PM r_towle make sure all your fuel injectors are plugged in t... Apr 22 2011, 07:34 PM jsayre914 just made it home. :chow:
that ride sucked!
... Apr 22 2011, 08:47 PM jsayre914 Intake valve was almost 2 full turns to tight :bli... Apr 22 2011, 10:30 PM ppetion :( :( :( :( We are waiting for the results........ Apr 22 2011, 10:49 PM jsayre914 ALL 4 are BANGING!!!
:Qarl: :Qarl: ... Apr 22 2011, 11:02 PM avidfanjpl I know all about badly adjusted valves.
My car ra... Apr 22 2011, 11:13 PM euro911 My wife's 1.7L ran 'OK' when we acquir... Apr 23 2011, 01:06 AM tomeric914 Glad you found the problem and fixed it
Valves we... Apr 23 2011, 09:31 AM jsayre914 Car ran great on the way home from hershey. I then... Apr 25 2011, 09:31 PM r_towle check the adjustment again.
Two things....did you... Apr 26 2011, 03:54 PM ppetion The sound system needs the other 2 cylenders to ru... Apr 26 2011, 04:03 PM
jsayre914
The sound system needs the other 2 cylenders to r... Apr 27 2011, 01:10 PM Vacca Rabite You got a lot done in an hour. All that usually ta... Apr 27 2011, 01:52 PM Eric_Shea
The valve seat you dropped. ;) Apr 27 2011, 02:13 PM jsayre914
The valve seat you dropped. ;)
read carefully... Apr 27 2011, 03:13 PM r_towle if you are planning to remove the heads...its obvi... Apr 27 2011, 02:30 PM r_towle a seat that is getting beat into the head would al... Apr 27 2011, 03:56 PM jsayre914 i am pulling the head either tonight or tommorow d... Apr 27 2011, 04:22 PM Dr Evil :popcorn:
I am so proud of you doing this on your... Apr 27 2011, 06:21 PM jsayre914 Looks like my intake seat has been hammerd inward ... May 10 2011, 10:19 AM jsayre914 the head
Number 2
Number 1
May 10 2011, 10:20 AM jsayre914 the seat
the good side
May 10 2011, 10:22 AM Vacca Rabite I see head leaks too. You really won't like th... May 10 2011, 10:33 AM jsayre914
I see head leaks too. You really won't like t... May 10 2011, 11:09 AM type47
You really won't like the probable cause. :(
... May 10 2011, 02:27 PM jsayre914 I just checked the old thread.... YUP its the exac... May 10 2011, 11:48 AM Cap'n Krusty I have to repeat myself once again. There are goo... May 10 2011, 05:16 PM scotty b Joe, my machinist down here is really good and use... May 10 2011, 05:18 PM jsayre914 so what is the verdict?
Rimco did a pisspoor job ... May 10 2011, 05:37 PM saigon71 Bummer on that valve seat Joe, but at least Rimco ... May 10 2011, 06:53 PM jsayre914
Bummer on that valve seat Joe, but at least Rimco... May 10 2011, 07:19 PM ppetion Why r we blaming rimco? it'scaused by vibratio... May 10 2011, 08:48 PM jsayre914 So...... :popcorn: ........ :( ........... :popcor... May 16 2011, 03:15 PM jsayre914 Just called me back 6pm May 16 two thousand and el... May 16 2011, 04:05 PM saigon71 Man, they are giving you a good "rimming.... May 16 2011, 04:23 PM jsayre914
Man, they are giving you a good "rimming.... May 16 2011, 05:18 PM saigon71
Man, they are giving you a good "rimming.... May 16 2011, 06:13 PM type47 You need to surf more throughly, you missed mepste... May 16 2011, 05:47 PM jsayre914 Your gonna love this shit :D :rotfl:
I got the ... May 18 2011, 10:38 AM jsayre914 This might help you understand. :first: May 18 2011, 10:51 AM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 22nd December 2024 - 05:17 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.