 Rear Hub Removal, Without removing the trailing arm |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| rjames |
 Jul 25 2011, 12:22 AM
Post
#1
|
|
I'm made of metal  Group: Members Posts: 4,158 Joined: 24-July 05 From: Shoreline, WA Member No.: 4,467 Region Association: Pacific Northwest 
 |
Trying to remove the rear hub. The CV/Axle is already removed. That was cake in comparison.
Have some pipe that is roughly the same OD and hammering the hell out of it got the hub to push out a couple of mm but now it won't budge. Hate the idea of spending $80 on a slide hammer. Any other tricks to get this bugger out? This is the driver's side. SO not looking forward to going through this process again on the other side of the car. |
   |
 
|
  |
Replies
| wingnut86 |
Jul 25 2011, 05:49 AM
Post
#2
|
|
...boola la boo boola boo... Group: Members Posts: 1,053 Joined: 22-April 10 From: South Carolina Member No.: 11,645 Region Association: South East States |
A good torch (Home Depot/Lowes - $29.95) is your friend.
Don't forget the PB Blaster or similar. Let it sit after application of both, for a little bit at least. Don't give up, metal is FUN (IMG:style_emoticons/default/headbang.gif) |
|
|
|
Posts in this topic
rjames Rear Hub Removal Jul 25 2011, 12:22 AM
Spoke After I pounded on the rear swing arm a bit and th... Jul 25 2011, 07:06 AM SLITS I use a 2 lb sledge hammer and pipe. I've nev... Jul 25 2011, 07:08 AM HAM Inc
Me too. I made this puller from the parts in the... Jul 25 2011, 07:33 AM
rjames
Me too. I made this puller from the parts in th... Jul 25 2011, 10:50 AM
John Jentz
Me too. I made this puller from the parts in th... Jul 25 2011, 07:30 PM mskala
Me too. I made this puller from the parts in t... Jul 26 2011, 10:47 AM wndsrfr As you know from my other post, I'm in the mid... Jul 25 2011, 07:41 AM rjames
Tried that, but can't get a wrench on 2 of t... Jul 25 2011, 10:40 AM wingnut86 HEAT, apply it liberally with a torch after the PB... Jul 25 2011, 10:58 AM matthepcat You need a heavier hammer. Mine was a pain until I... Jul 25 2011, 09:37 PM |
4 User(s) are reading this topic (4 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 04:13 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.