 Repacking CV joints and replacing rear wheel beari |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| lmcchesney |
 Apr 20 2004, 05:23 PM
Post
#1
|
|
Member  Group: Members Posts: 488 Joined: 24-November 03 From: Ocala, Fl. Member No.: 1,381 Region Association: None  |
I can't find a tech article on the replacing of rear wheel bearings and re packing of CV joints. Does anyone know of a tech article of the same. I replaced the front wheel bearings and while the 914 is up on stands, I might as well complete the project.
Thanks, L. McChesney |
   |
 
|
  |
Replies
| maxwelj |
Apr 21 2004, 10:22 AM
Post
#2
|
|
rebuilt member Group: Benefactors Posts: 278 Joined: 8-January 04 From: Owasso, OK Member No.: 1,532 Region Association: None 
|
After you get done, how do you insure that the "Hats" are on straight? The first time I tried, I tightened down the little beveled screws and the disc bound on the caliper (W/o pads, even!) I then just spun and tightened, spun and tightened until I had clearance. Is that the proper way?
|
|
|
|
Posts in this topic
lmcchesney Repacking CV joints and replacing rear wheel beari Apr 20 2004, 05:23 PM
Bleyseng PP has a tech article on the rear bearings install... Apr 20 2004, 06:25 PM lmcchesney Thanks Geoff,
Dave clued me into the PP tech artic... Apr 20 2004, 06:53 PM Bleyseng Yep, went in after work today and I noticed atleas... Apr 20 2004, 07:31 PM lmcchesney OOOhhhh. Don't get me started.
L. McChesney Apr 20 2004, 07:54 PM 415PB I just did this two weeks ago. I pounded with the ... Apr 20 2004, 09:16 PM Jeffs9146 I just finished assembling my trailing arms and I ... Apr 21 2004, 10:01 AM Jeffs9146 Custom hitech tools needed!! ;)
Jeff Apr 21 2004, 10:04 AM Jeffs9146 More tools!
Jeff Apr 21 2004, 10:05 AM Jeffs9146 I put the drive shaft through and tighten it until... Apr 21 2004, 05:54 PM 415PB Jeff, that looks very clean. Good job! Apr 21 2004, 06:09 PM Jeffs9146 QUOTE
lmcchesney Thanks all,
Will have to put the beast back on jac... Apr 22 2004, 09:24 AM
neo914-6 QUOTE
|
4 User(s) are reading this topic (4 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th December 2024 - 10:12 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.