 valve clearance |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| fitzm1 |
 Sep 10 2011, 11:42 AM
Post
#1
|
|
Member  Group: Members Posts: 74 Joined: 21-April 08 From: Ballston lake,ny Member No.: 8,947 Region Association: None  |
So I decide its time to check for valve clearance. Each was a little tight. Very good. Got them dead on. Then I look at the no. 3 ex push rod tube thats been leaking and realize that I can get this one out pretty easy. Out it comes, in go the new o rings and back in it goes. I replace the rocker arms and recheck the clearances expecting them to be a little off but they were very tight. Could taking off the rocker arms and replacing them change the clearances that much? I had to unscrew the adjuster at least one ful turn.
|
   |
 
|
Posts in this topic
Cap'n Krusty The pushrods aren't seated. The valve adjustm... Sep 10 2011, 12:47 PM
Als914 Sounds like your #3 push rod was not seated correc... Sep 10 2011, 12:48 PM fitzm1 Both the 3 intake & exhaust were tight. After ... Sep 10 2011, 01:53 PM fitzm1 There is one other reason the valve clearances cha... Sep 11 2011, 03:58 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st October 2024 - 08:19 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.