 Powdercoating trailing arms, places to avoid? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 3liter914-6 |
 Apr 29 2004, 12:45 PM
Post
#1
|
|
Master of Clueless Posts  Group: Benefactors Posts: 310 Joined: 12-October 03 From: State College, PA Member No.: 1,238 Region Association: MidAtlantic Region   |
Ok, so thanks to you guys I've got two trailing arms lying on my garage floor. I figure since I've got them out and am installing the needle bearings and 911 e-brake, I might as well get the whole dealio powdercoated.
What I'm wondering is besides threads and bearing surfaces, the usual suspects, are there other places to mask off? I'm thinking if I powdercoat the surfaces of the alignment shim mount, that's going to throw things off, right? So should I just clean that piece up and not coat it, or just go ahead and do it and adjust with shims afterwards. No matter what, even if I put it back together with just new bushings, I'm going to have to mess around with the shims, right? Thanks for any help, Adam |
   |
 
|
Posts in this topic
Mueller do not powercoat the inside of the trailing arm th... Apr 29 2004, 01:19 PM 3liter914-6 <... Apr 29 2004, 01:24 PM Mueller the only real reason to press the tubes in before ... Apr 29 2004, 01:28 PM
3liter914-6 <... Apr 29 2004, 02:34 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th November 2024 - 11:28 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.