 Transmission input shaft seal mystery, have never seen this style seal-should I replace it? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| reharvey |
 Dec 15 2011, 11:26 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 573 Joined: 16-July 08 From: N. E. Ohio Member No.: 9,308 Region Association: North East States  |
I have a low mileage 72 trans ( 6000mi. ) that I'm converting to a side shifter. It has a front seal that is very different from the one in the 74 trans that is being used for linkage parts. The black seal in the 74 trans is usually what is found on all the cases I've dismantled. . The sealing area on the blue 72 is inset much deeper into the case and the outer surface sits a machined area not used on the 74 black seal. I'm sure the 72 trans has never been apart so it's an original piece. So, should I knock it out and use the seal that is in the gasket set?
Also got to say that it's great to take a trans apart and see everything inside looks like new! Attached thumbnail(s)  
|
   |
 
|
  |
Replies
| Richard Casto |
Dec 15 2011, 04:13 PM
Post
#2
|
|
Blue Sky Motorsports, LLC Group: Members Posts: 1,465 Joined: 2-August 05 From: Durham, NC Member No.: 4,523 Region Association: South East States |
Be careful to not scratch the bore in the case when you remove the seal. If the case is still apart you can tap it out from the inside. If the transmission is still together you can use a seal puller, or screw a small screw into the seal and use that to pull it out. Those seals fit tightly. I lubricate mine when I install them and as it's easy to tear them if you are not careful.
Richard |
|
|
|
Posts in this topic
reharvey Transmission input shaft seal mystery Dec 15 2011, 11:26 AM
jcd914 I doubt either are original seals. The blue seal i... Dec 15 2011, 02:13 PM 02loftsmoor Contact Dr. Evel. Dec 15 2011, 02:15 PM Richard Casto To do the side shift conversion you already have i... Dec 15 2011, 03:00 PM
reharvey
To do the side shift conversion you already have ... Dec 15 2011, 04:02 PM Cap'n Krusty The blue seal is an early version, used on 356s an... Dec 15 2011, 03:00 PM reharvey
Be careful to not scratch the bore in the case wh... Dec 15 2011, 04:19 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th December 2024 - 11:45 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.