intake tube alignment, 3/4 tube to the distributor is off |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
intake tube alignment, 3/4 tube to the distributor is off |
malcolm2 |
Mar 21 2012, 06:44 PM
Post
#1
|
Advanced Member Group: Members Posts: 2,747 Joined: 31-May 11 From: Nashville Member No.: 13,139 Region Association: South East States |
Well, I did not pay enough attention as I was taking this engine apart. I cleaned, blasted and painted the intake tubes and the "intake distributor" (please correct me if I have mis-named). Anyway, I am a good 1/4" off center on the #3 cylinder intake tube, left tube. This can't be good or right, can it? I can get the short rubber hose on,
this kind of offset will leak right? the 1/2 side lines up nicely |
Valy |
Mar 21 2012, 07:18 PM
Post
#2
|
Senior Member Group: Members Posts: 1,677 Joined: 6-April 10 From: Sunnyvale, CA Member No.: 11,573 Region Association: Northern California |
Looking at the pictures again, I see 2.0 runners and 1.8 box.
If you replace the heads to 3 studs, just drill the 1.8 runners. |
02loftsmoor |
Mar 21 2012, 07:39 PM
Post
#3
|
Senior Member Group: Members Posts: 577 Joined: 26-June 11 From: Ft. Worth TX Member No.: 13,243 Region Association: Southwest Region |
|
Lo-Fi Version | Time is now: 20th October 2024 - 06:53 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |