 Pushrod tube seal replacement |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| matt5596 |
 Mar 18 2013, 07:30 PM
Post
#1
|
|
Member  Group: Members Posts: 102 Joined: 28-September 11 From: Norris, TN Member No.: 13,619 Region Association: South East States  |
(IMG:style_emoticons/default/headbang.gif) I'm replacing the pushrod tube seals on my 1.7 (engine is in car) with Viton seals from Pelican. The existing seals are so bad I could spin the tubes by hand with no effort - no wonder it leaks so bad. So I started with #1, got the old ones off, cleaned the tubes and put the new seals on. I cannot get them back in. I've lubed them with a bit of motor oil and I'm trying to spin as I insert them but they will not go. (IMG:style_emoticons/default/WTF.gif)
|
   |
 
|
  |
Replies
| stateofidleness |
Mar 18 2013, 11:09 PM
Post
#2
|
|
Senior Member Group: Members Posts: 810 Joined: 1-September 07 From: Canyon Lake, Texas! Member No.: 8,065 Region Association: None |
I just did this last weekend. I lubed the o-rings and held the tube in place from underneath, while my dad pressed on the tube from the end with the back side of a screwdriver (the round side). This allowed it to fit perfectly in the open end of the tube and while he was applying the "forward" pressure to get it to into the head, I was rotating as it was going in. All went in without much trouble!
|
|
|
|
Posts in this topic
matt5596 Pushrod tube seal replacement Mar 18 2013, 07:30 PM
McMark There are some early 1.7 engines that have differe... Mar 18 2013, 07:47 PM Dasnowman Oh no I just bought an engine seal kit and it was ... Mar 18 2013, 07:54 PM matt5596 Here's what came out compared to the new seals... Mar 18 2013, 07:57 PM 914itis I use Vaseline and a wise grip to hold it and pus... Mar 18 2013, 08:00 PM Dave_Darling Oil on the O-rings, and twist and push them in. T... Mar 18 2013, 08:12 PM McMark Nope, those look right.
The small pushrod tubes o... Mar 18 2013, 08:45 PM ThePaintedMan Huh... I didn't know there was a difference on... Mar 18 2013, 08:50 PM matt5596 Vice grip did the trick. #1 compete. Thanks. Mar 18 2013, 09:07 PM 914itis :headbanger: Mar 18 2013, 11:13 PM
McMark
Only on a very few very early engines. Most 1.7s... Mar 18 2013, 11:27 PM |
5 User(s) are reading this topic (5 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th December 2024 - 12:48 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.