75 LJet will not fire, finishing restoration Options

[malcolm2]

Ok I think I am good on the seat belt relay. YLW and YLW/red are spliced. And I have checked for continuity all the way from the starter to the key on that wire.

I have spark, points checked too.

I have fuel pressure, about 40 psi, checked between p-side fuel rail and cold start valve.

Starter works fine

oil pressure builds, light goes out on the dash

Engine timing is still at rebuild setting...0 TDC.

Re-built FI & Ignition & Alt harnesses

I did have trouble with the key switch, so the steering wheel is out, levers are not connected and I turn a screw driver on the end of the key connector to fire the starter, should not be an issue, correct?

I got the L-jet trouble shooting "no start" pages to try tomorrow.

Any other ideas? I am baffled. (IMG:style_emoticons/default/confused24.gif)

[timothy_nd28]

The car will run off ether, pull off the AFM and squirt it directly in the rubber boot. You should also verify that the injectors are not firing, by pulling one and placing it into a glass jar. It is exceedingly rare, but the ECU could be at fault here.

You have spark, and fuel pressure. You also have power going to the ECU on pin 10, and all the grounds pins 5, 16,17 fixed. We checked the continuity of all injectors and resistor pack by verifying voltage on pins 14,15,32 and 33. The CHT is present and within spec as well as the continuity of pin 1 to the ignition coil. I'm speculating that you have a bad brain unit. But before you order a new one, pull a injector and make sure it's not spraying fuel.