recent Sebring Abuse, Oil system help Options

[Jetsetsurfshop]

Hey Everyone (IMG:style_emoticons/default/biggrin.gif)
Here's what I'm running
2258cc
10.5 to 1 compression
40 webers
494 web cam
type 1 oil pump
mocal oil cooler 25 row
mocal sandwich w/thermostat adapter
accusump 2 quart
Brad Penn Air-cooled oil 15-50 (5 1/2 quarts)

Let me explain my set-up
The oil cooler is a rear mount under the car on the passenger side rear. I made some duct work and its almost vertical to catch the most air as possible.
Track conditions
Sunny, low 80s, 30min sessions

question 1) With that cooler I didn't expect to run in the 230f oil temps. Is 230f acceptable?
question 2) I also have some oil on the top of the case /engine tin pooling. 1-2 side.
It only happens under WOT. Any ideas?
question 3) I never set-up an accusump and I don't like it so far.
It over fills the case at shut-off. Do I have to much air in it (9lbs)?
Other then my oil questions, I had a great time. Ran a 2:51. My new best time.
(IMG:style_emoticons/default/smilie_pokal.gif)

[ChrisFoley]

An accusump is an engine saver if its set up correctly.
It's important to shut the valve while the oil pressure is high so the accusump is fully charged.
The system should incorporate a check valve to force the accusump to feed the bearings and not the oil pump.

230F oil temp is ok if your pressure is good.
A front mounted cooler may be necessary if the temp goes any higher.
In that case use dash 12 lines to keep pressure loss to a minimum.