Pictures of Body Dimension X Measurement Points Options

[cary]

I was wondering if any one has pictures of exactly where to measure body dimension X. Targa bar to windshield frame.

This car was a front clip repair back in the beginning of its life.
http://www.914world.com/bbs2/index.php?act...=2&t=187546
If it needs to be tweaked, now is the time.

TIA for the help ........................

[cary]

Thanks for the guidance.
I'll get it lowered from the 2 post lift tomorrow.
No suspension, so we'll MacGyver something after we get it leveled on the floor.

I think I'm OK on the sag.
It was always supported on all 4 outside corners. Screw jack under the rotisserie hanger. We'll see.



I never had it supported under the "A" pillar. I used that as my adjustment point for installing the longs.



On the lift ............... Supported with this frame.



On the lift ............
"F" is perfect on the right where I haven't finished the inner rocker install. UNSPRUNG
"F" on the left is 25 1/16. UNSPRUNG. I can push it out to 25 1/8, but springs back.
Not enough threads on the Hiem joint to push it out far enough to adjust.


I'll report back tomorrow night after I get it on the floor, on jackstands.

Here's the other guidance I'm using.

http://www.914world.com/bbs2/index.php?sho...03941&st=50

http://www.914world.com/bbs2/index.php?sho...75069&st=25

I have both a big and little Porta Power so I should be OK.