 Oil pressure sender, installation torque |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| boxsterfan |
 Mar 26 2014, 12:24 PM
Post
#1
|
|
914's are kewl  Group: Members Posts: 1,776 Joined: 6-June 03 From: San Ramon, CA Member No.: 791 Region Association: Northern California  |
So my 2.0L has oil leaks and mine is likely leaking from the oil pressure sender. At least that is is the "easy fix" hope. Otherwise, I'll have to look at oil cooler seal or pushrod tube seal leaks.
When under the motor, I can always see a droplet of oil building up on the filter so it's likely coming from above there. Plus, there is oil up top in the oil pressure sender aea, but some of that could be coming from the oil filler gasket area also. I'm not ready to spend the money on dual sender with VDO oil pressure gauge in the cockpit so I went the cheaper route and got the $5.25 replacement switch from PP. However, I can't find any previous posts on how much torque should be applied when tightening in the replacement sender? I suspect it is not much? (5-10 ft/lbs?) Snug it up by hand (deep socket with extension) and then turn 1/4 turn? Need to be careful not to break the new one I hear. TIA... |
   |
 
|
  |
Replies
| JawjaPorsche |
Mar 26 2014, 02:17 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 3,463 Joined: 23-July 11 From: Clayton, Georgia Member No.: 13,351 Region Association: South East States |
When I tried to remove the old one it broke. That was a bitch! (IMG:style_emoticons/default/sad.gif)
|
|
|
|
Posts in this topic
boxsterfan Oil pressure sender Mar 26 2014, 12:24 PM
The Cabinetmaker use your bolt sense and tighten it enough to not l... Mar 26 2014, 12:30 PM Cap'n Krusty It's a tapered (pipe) thread, and the senders ... Mar 26 2014, 12:56 PM
|
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 22nd December 2024 - 01:00 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.