 /6 Conversion Clutch Question |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| patssle |
 Apr 14 2014, 02:47 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 981 Joined: 28-August 09 From: Houston, TX Member No.: 10,741 Region Association: None  |
For my 3.0L SC motor with Weber carbs to a 901 transmission - I'm planning on a new Kennedy 228mm flywheel and 228mm Stage II pressure plate.
My existing 215mm 914 4 spring clutch disc still has life left on it - can this be used at all? I've seen some notes that 215mm can be used on 228mm flywheels...is this true or do I need the 228 with 6 springs for a /6 engine? Thanks. |
   |
 
|
  |
Replies
| ClayPerrine |
Apr 14 2014, 03:33 PM
Post
#2
|
|
Life's been good to me so far..... Group: Admin Posts: 15,594 Joined: 11-September 03 From: Hurst, TX. Member No.: 1,143 Region Association: NineFourteenerVille 
|
QUOTE(patssle @ Apr 14 2014, 03:47 PM)  For my 3.0L SC motor with Weber carbs to a 901 transmission - I'm planning on a new Kennedy 228mm flywheel and 228mm Stage II pressure plate. My existing 215mm 914 4 spring clutch disc still has life left on it - can this be used at all? I've seen some notes that 215mm can be used on 228mm flywheels...is this true or do I need the 228 with 6 springs for a /6 engine? Thanks. You can't use a 215mm disk with a 225mm flywheel and pressure plate. To use a 215mm clutch, you have to have an early 911/914-6 flywheel. But that won't fit a 3.0SC motor. You can get an adapter flywheel from Kennedy engineering. But you would have to use the 215mm pressure plate with the adapter flywheel. |
|
|
|
Posts in this topic
patssle /6 Conversion Clutch Question Apr 14 2014, 02:47 PM
Mark Henry A 3.0 to 901 conversion uses a stock 911 flywheel,... Apr 14 2014, 04:17 PM patssle Great, thanks guys. I was wondering why I had read... Apr 14 2014, 06:14 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 29th June 2024 - 12:17 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.