 All this talk about dipping/blasting...., What to do if you can't afford either? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bondo |
 Aug 12 2004, 06:16 PM
Post
#1
|
|
Practicing my perpendicular parking  Group: Members Posts: 4,277 Joined: 19-April 03 From: Los Osos, CA Member No.: 587 Region Association: Central California  |
I'm on a serious budget here, and I'm in the process of removing paint/seam sealer/rust. I've got most things under control, but what's the best way to get that nasty rust harboring foam out of the corners of the rear fenders? Also, where else did they put that junk? Aslo, what's the best way to remove undercoating?
|
   |
 
|
  |
Replies
| Sparky |
Aug 13 2004, 08:05 AM
Post
#2
|
|
Mahna Mahna! Group: Members Posts: 1,134 Joined: 21-June 03 From: Spencer, MA Member No.: 847 |
If your down to metal only on the tub take it to a large powder coating company and ask them to burn it for you. Most powder companies burn paint off of metal then lightly blast it to remove any residue.
Good luck! Mike D. |
|
|
|
Posts in this topic
bondo All this talk about dipping/blasting.... Aug 12 2004, 06:16 PM
GWN7 On a budget.....use grease...elbow grease. Lots of... Aug 12 2004, 06:25 PM jkeyzer Britain knows. I think he uses a special wire whe... Aug 12 2004, 06:37 PM bondo Of all these, I can only see the heat gun doing an... Aug 12 2004, 07:27 PM silver2.0 A torch will distort the metal, Just use paint rem... Aug 12 2004, 07:35 PM i love porsche ive been doing this the entire summer to my car... Aug 12 2004, 09:38 PM ThinAir914 Well I'm a long way from getting back to work ... Aug 12 2004, 11:22 PM jgiroux67 How much does an acid dip cost?
Oh yeah for the s... Aug 13 2004, 12:16 AM Mike9142.0 <... Aug 13 2004, 01:52 AM
1bad914 I use a propane torch and a wide bladed chisel to ... Aug 13 2004, 08:25 AM |
4 User(s) are reading this topic (4 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 22nd December 2024 - 12:03 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.