 914-6, rear drive hub studs |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Grit |
 Sep 18 2014, 07:09 PM
Post
#1
|
|
Newbie  Group: Members Posts: 1 Joined: 18-September 14 From: Roseburg, Oregon Member No.: 17,918 Region Association: Pacific Northwest  |
Brand new to this site, working on 74 , drilling out the rear hubs and rotors, what size stud is used for this conversion? I can machine them myself but do not have knowledge of stud used...
|
   |
 
|
  |
Replies
| Wdunster |
Sep 18 2014, 07:57 PM
Post
#2
|
|
Panel beater Group: Members Posts: 172 Joined: 10-June 14 From: Monroe,nc Member No.: 17,469 Region Association: South East States |
I believe you need a 14mm drill bit and the factory stud will press in the hole. I did this conversion about 8 years ago.
|
|
|
|
Posts in this topic
Grit 914-6 Sep 18 2014, 07:09 PM
sixnotfour you need to spot face the backside ..also, or they... Sep 18 2014, 08:41 PM John Jentz
Brand new to this site, working on 74 , drilling ... Sep 19 2014, 09:53 AM
oldschool :wttc: let the madness begin :Qarl: Sep 19 2014, 10:41 AM sled9146
:wttc: let the madness begin :Qarl:
I have facto... Sep 19 2014, 12:05 PM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th December 2024 - 02:44 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.