 Anyone know how to set float levels on dual 40 IDF weber carbs? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| LCOX |
 Oct 10 2014, 05:58 PM
Post
#1
|
|
Member  Group: Members Posts: 93 Joined: 19-December 09 From: Pinnacle Member No.: 11,148 Region Association: None  |
've got a set of dual webers IDF 40 carbs.
Anyone know how to properly set the float level height on these things. I've got a set of vernier calipers. I'm sure you probably carefully bend one or both of the metal tabs on each float assembly. What is the proper closed figure and the fully open figure. Thanx all L. |
   |
 
|
  |
Replies
| r_towle |
Oct 11 2014, 08:29 AM
Post
#2
|
|
Custom Member Group: Members Posts: 24,594 Joined: 9-January 03 From: Taxachusetts Member No.: 124 Region Association: North East States 
|
10mm from the gasket with the body held vertical is how I do it.....seems to work for me. 12 mm without the gasket.
Bend the little tab to adjust it. Be accurate and patient...takes a few attempts |
|
|
|
Posts in this topic
LCOX Anyone know how to set float levels on dual 40 IDF weber carbs? Oct 10 2014, 05:58 PM
arkitect Did a search and the info I found was 10mm closed ... Oct 11 2014, 06:25 AM Mblizzard A little tip I got from someone. Use a 10 mm bolt... Oct 11 2014, 09:16 AM pilothyer If this helps any.......Also when you measure the ... Oct 11 2014, 09:33 AM stugray Diagram in post above is from here:
http://www.re... Oct 11 2014, 10:45 AM
McMark
If this helps any.......Also when you measure the... Oct 11 2014, 12:37 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th June 2024 - 07:41 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.