![]() |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
![]() |
Qarl |
![]()
Post
#1
|
Shriveled member ![]() ![]() ![]() ![]() ![]() Group: Benefactors Posts: 5,233 Joined: 8-February 03 From: Florida Member No.: 271 Region Association: None ![]() ![]() |
I will be replacing my center tunnel fuel lines with some stainless steel hardline from Summit Racing.
I will connect the fuel tank to the pump and ten to the tunnel fuel line inlet with normal fuel hose and hose clamps. On the engine firewall side, I'd like to switch over to braided stainless -AN line to run to the filters and to the carbs. I have seen pipe to -AN Aeroquip tubes/sleeve fittings at Summit Racing... * 5 Aeroquip tube nuts, AER-FCM3675 * 5 Aeroquip tube sleeves, AER-FCM3671 My question is... I assume that I need to flare the end of the pipe that the pipe to -AN tube/sleeve mounts to, correct? (Of course flaring it after first sliding the nut and sleeve over the line) Do I make a single flare, or a double flare? I have seen both types of brake line flarerers at the auto parts store. Any help/guidance would be appreciated. Thanks, Karl |
![]() ![]() |
Zeke |
![]()
Post
#2
|
Never left, but not right.... ![]() ![]() Group: Members Posts: 391 Joined: 26-January 03 From: Long Beach CA Member No.: 197 Region Association: None ![]() |
Is a ferrule (sp?) type compression fitting available for that connection/transition?
|
![]() ![]() |
![]() |
Lo-Fi Version | Time is now: 11th March 2025 - 01:03 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |