 Bike Rack Compilation Thread |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
  |
Replies
| Joe Owensby |
 Oct 23 2010, 10:27 PM
Post
#2
|
|
JoeO  Group: Members Posts: 527 Joined: 7-January 06 From: Spartanburg, SC Member No.: 5,385 Region Association: South East States  |
Here are some photos of my set up. I have a 1 1/4 inch receiver mounted just below the bumper. This enables me to leave the tag in place. It accepts a standard bike carrier. I have a set of bars that attach to the rear receiver, and also to the rear of the roll bar. This allows me to carry 2 kayaks. It doesn't add any load to the front windshield frame, and also allows me to remove the top if I want. I can also access both the rear trunk and engine compartment with everything installed and loaded. The receiver has a steel tube that is supported on the rear of the car by two 3/16 inch bars. The inner portion of the tube is welded to a 1/2 inch bar that is bent to go up and over the muffler and transmission. I have a few bolts through the trunk floor that hold the 1/2 inch bar. I have trailered a 30 foot long sailplane trailer with this set up, no problems. JoeO
 |
   |
 
|
| thieuster |
Apr 16 2015, 01:56 PM
Post
#3
|
|
Member Group: Members Posts: 447 Joined: 31-January 15 From: 275 mls NW from Stuttgart. Member No.: 18,384 Region Association: Europe |
QUOTE(Joe Owensby @ Oct 24 2010, 06:27 AM)  Here are some photos of my set up. I have a 1 1/4 inch receiver mounted just below the bumper. This enables me to leave the tag in place. It accepts a standard bike carrier. I have a set of bars that attach to the rear receiver, and also to the rear of the roll bar. This allows me to carry 2 kayaks. It doesn't add any load to the front windshield frame, and also allows me to remove the top if I want. I can also access both the rear trunk and engine compartment with everything installed and loaded. The receiver has a steel tube that is supported on the rear of the car by two 3/16 inch bars. The inner portion of the tube is welded to a 1/2 inch bar that is bent to go up and over the muffler and transmission. I have a few bolts through the trunk floor that hold the 1/2 inch bar. I have trailered a 30 foot long sailplane trailer with this set up, no problems. JoeO Inspiring! Gives me even a chance to haul my son's Optimist dinghy to the summer regattas. (Will top the Belgian father with a Panamera + trailer with an Optimist and a 12" RIB!) Menno |
|
|
|
Posts in this topic
Andyrew Bike Rack Compilation Thread Oct 19 2010, 05:20 PM
Andyrew Reserved
UPDATE 10-27-10
I went and picked up so... Oct 19 2010, 05:21 PM racerbvd Why not mount a Yakima Tray & fork on an extra... Oct 19 2010, 05:28 PM
Andyrew
Why not mount a Yakama Tray & fork on an extr... Oct 19 2010, 05:35 PM
racerbvd
Why not mount a Yakama Tray & fork on an ext... Oct 19 2010, 06:15 PM mepstein
Why not mount a Yakama Tray & fork on an extr... Oct 19 2010, 05:51 PM Andyrew I think that my setup is going to be a combo of Jo... Oct 19 2010, 05:33 PM Tom_T
Here are some aftermarket options. (From Bowlsby... Oct 19 2010, 07:36 PM mepstein I don't know if our targa tops are thicker tha... Oct 20 2010, 07:30 AM Tom_T
I don't know if our targa tops are thicker th... Oct 20 2010, 01:05 PM Andyrew Wonderful Info guys! I'll update the first... Oct 19 2010, 07:40 PM Elliot Cannon Mine has been tested at 110 MPH with the bike on i... Oct 19 2010, 07:53 PM Andyrew Thanks for the input Elliot! Think you could a... Oct 19 2010, 08:24 PM Gint Excellent thread. Thanks for posting this Andrew.... Oct 19 2010, 09:10 PM Andyrew Gint, His thread is located under his pics, AS wit... Oct 19 2010, 09:21 PM Gint Sweet, thanks. Didn't see it hiding there. Oct 19 2010, 09:24 PM Andyrew Good point, I moved the links above the pics and p... Oct 19 2010, 09:30 PM Gint Much better. Again, great thread. Oct 19 2010, 09:36 PM Andyrew mepstein,
If you could post some pictures of you... Oct 20 2010, 08:54 AM mepstein Car is being restored. This will have to do for no... Oct 20 2010, 09:51 AM Andyrew Thanks! I was hoping you had a pic from the ye... Oct 20 2010, 09:56 AM majkos Here's mine :D
Oct 20 2010, 11:58 AM Andyrew
Here's mine :D
Kevin, Awesome hitch moun... Oct 20 2010, 12:28 PM Rand My $.02, I would bolt a Yakima type system to... Oct 20 2010, 12:19 PM majkos With lead designer from Alien, Rick
we came up wi... Oct 20 2010, 02:34 PM majkos Sacrifice a very nice bumper. :evilgrin: Oct 20 2010, 02:39 PM Tom_T
Sacrifice a very nice bumper. :evilgrin:
Intere... Oct 20 2010, 03:28 PM majkos Answers
1) Very easy to set up, no scratches
2)Sam... Oct 20 2010, 02:51 PM Andyrew I dont see a locking pin on that receiver, was tha... Oct 20 2010, 03:00 PM majkos
I dont see a locking pin on that receiver, was th... Oct 20 2010, 03:20 PM Nürburg Nomad Some very cool looking bike rack setups... I do a ... Oct 20 2010, 03:33 PM Andyrew Great info all! Keep it coming!
Tom, Im ... Oct 20 2010, 03:59 PM Tom_T
Great info all! Keep it coming!
Tom, Im... Oct 20 2010, 04:03 PM Andyrew You could probably tie into the trani mounts and h... Oct 20 2010, 04:16 PM Tom_T
You could probably tie into the trani mounts and ... Oct 20 2010, 04:30 PM jmargush Here is the one I just started the other week. Wi... Oct 20 2010, 05:13 PM Andyrew Can you upload the pics any bigger? You can upload... Oct 20 2010, 05:22 PM majkos no easy solution on mounting a hitch to the trans ... Oct 20 2010, 06:03 PM Tom_T
maybe i should go for a bike ride tommorrow......... Oct 20 2010, 08:14 PM jmargush Yes I took a piece of angle iron and welded it to ... Oct 21 2010, 06:39 AM Andyrew Wonderful! When you post the rest of the pictu... Oct 21 2010, 09:20 AM jmargush Pretty easy to set up one person can do it. doesn... Oct 22 2010, 11:20 AM jmargush more! Oct 22 2010, 11:21 AM Andyrew Awesome! Out of curiosity, why did you go so w... Oct 22 2010, 12:39 PM jmargush
Awesome! Out of curiosity, why did you go so ... Oct 22 2010, 02:53 PM JTarver I had a rack left over from my Saturn when I took ... Oct 22 2010, 04:49 PM Andyrew Got any pics with the bike mounting? If so I'l... Oct 22 2010, 05:13 PM JTarver Actually, the bike mounting is up there right besi... Oct 22 2010, 08:28 PM broomhandle Actually, the bike mounting is up there right besi... Oct 22 2010, 09:34 PM Andyrew Yes, Please review!! Wonderful setup! ... Oct 22 2010, 09:43 PM JTarver Actually on the highway it does just fine. At lea... Oct 23 2010, 04:58 PM Joe Owensby Side view of both bars, and detail of rear end of ... Oct 23 2010, 10:33 PM Andyrew Joe,
I saw your rack and I like it! But I di... Oct 23 2010, 10:40 PM Joe Owensby Receiver is a standard 1 1/4 inch tube that is mou... Oct 24 2010, 09:33 AM Andyrew Just won this auction
http://cgi.ebay.com/ebaymoto... Oct 25 2010, 05:14 PM mepstein
Just won this auction
http://cgi.ebay.com/ebaymot... Oct 25 2010, 05:23 PM Andyrew
[quote name='Andyrew' post='1386801' date='Oct 25... Oct 25 2010, 06:00 PM Andyrew Got my setup!!
The raingutter mounts are... Oct 28 2010, 12:13 AM majkos I suggest some how connect the two plates, help br... Oct 28 2010, 08:32 AM Andyrew Ya I think it would be the easiest way to stabaliz... Oct 28 2010, 08:52 AM majkos Square tubing would be nice,
and if you want a one... Oct 28 2010, 08:58 AM Andyrew Aluminum? Way to much money :D
Tubing that slid... Oct 28 2010, 09:19 AM mettelman Added a second bike rack to my extra targa top. T... Jun 26 2013, 02:00 PM mettelman look at the way it hold on a side hill! Jun 26 2013, 02:05 PM 03blueboo I'm happy I found this thread. I plan on addi... Apr 16 2015, 01:41 PM bandjoey The rope rack :lol4: Apr 16 2015, 03:52 PM Chris H. Nice Bill. Looks highway ready to me. And to unl... Apr 16 2015, 04:19 PM 914Next Although, not cheap the SeaSucker company might ma... Apr 16 2015, 04:34 PM jim_hoyland I like the rack on the driver side. How is the fro... Apr 16 2015, 05:45 PM Elliot Cannon I made this rack back in 2005 and used it at the W... Apr 16 2015, 06:06 PM Andyrew
I made this rack back in 2005 and used it at the ... Apr 17 2015, 10:05 AM 76-914 Well I'll be. :poke: And I thought that you p... Apr 17 2015, 08:06 AM Ferg Modified pieper ski rack with Rockymounts thru axl... Oct 8 2016, 02:23 PM Ferg RE: Bike Rack Compilation Thread Oct 8 2016, 02:24 PM Ferg RE: Bike Rack Compilation Thread Oct 8 2016, 02:26 PM Jeff Bowlsby If that PO only knew what he had! At least 2 ... Oct 8 2016, 07:17 PM Rand Love it. Love the new Creamsicle, and the bike rac... Oct 8 2016, 02:57 PM RobW F ing show off! Nice work! :headbanger: Oct 8 2016, 04:11 PM Ferg He was told and knew or had an idea. He Didn... Oct 8 2016, 07:24 PM dangrouche Here is my rack, similar to a lot of others here; ... Oct 8 2016, 11:17 PM VaccaRabite Thread bump with my solution to this problem.
@[... Feb 28 2022, 09:00 PM Jett
Thread bump with my solution to this problem.
@... Feb 28 2022, 11:01 PM infraredcalvin I think using the ski rack mounts is one of the be... Feb 28 2022, 09:27 PM Superhawk996 @VaccaRabite
thank you for link. Like the creat... Mar 1 2022, 08:23 AM shredtherad i picked up a RockBros. suction bike rack setup an... Oct 24 2022, 09:31 AM NotLance Okay so instead of putting the bike on the car, pu... Jul 6 2023, 05:15 PM mepstein You went old school with the spinergy wheels. I ha... Mar 24 2024, 07:23 AM NotLance
You went old school with the spinergy wheels. I h... Mar 24 2024, 10:29 AM mepstein
You went old school with the spinergy wheels. I ... Mar 24 2024, 11:50 AM bkrantz Not a 914, but here is the rack I had on my Boxste... Mar 24 2024, 08:47 PM morehills Taking some suggestions from you all, I made a lit... Oct 29 2024, 03:22 PM morehills Full set up with Sea Sucker rear mount Oct 29 2024, 03:31 PM VaccaRabite
Full set up with Sea Sucker rear mount
What are... Oct 30 2024, 04:59 AM Front yard mechanic My bike rack single mount Oct 29 2024, 03:59 PM morehills Zach, I put it in the frunk. It fits nicely again... Oct 30 2024, 05:25 AM jd74914 @morehills
Nice ride-great kit! I recognize ... Oct 31 2024, 11:12 PM morehills
[b]@[url=http://www.914world.com/bbs2/index.php?s... Nov 1 2024, 04:47 AM jd74914 Nice! I think a lot of people are in that boat... Nov 1 2024, 12:22 PM |
7 User(s) are reading this topic (7 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 22nd November 2024 - 01:21 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.