 door handle problem, spins and spins |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jacksun |
 May 16 2015, 11:05 AM
Post
#1
|
|
Member  Group: Members Posts: 236 Joined: 8-August 13 From: mi Member No.: 16,224 Region Association: Upper MidWest  |
Hi,
trying to remove the door handles and the nut just spins.. so does the threaded stud.. A is where I scrapped away some of the rubber seal and the threaded stud is visable and it turns when the nut is wrenched. B is the nut that is scarred from the vise grips... wrench would just turn the nut and the threaded stud  C is the nut and stud in question.... a snip from an image of some one else's.  the car was painted with the handles on by some one previously. I would think that the threaded stud would just come out when wrenching the nut?? any ideas??? please... thanks randal |
   |
 
|
Posts in this topic
The Cabinetmaker Remove the door panel then remove the 5mm Allen sc... May 16 2015, 12:21 PM
URY914
Remove the door panel then remove the 5mm Allen s... May 17 2015, 03:35 AM jacksun tks for the reply....
I had already removed the d... May 16 2015, 12:55 PM Bartlett 914 The stud has broken free in the handle. You nay ne... May 16 2015, 01:03 PM URY914
The stud has broken free in the handle. You nay n... May 17 2015, 03:33 AM screenguy914 Try inserting a pry bar or equiv. in space A, betw... May 16 2015, 01:19 PM URY914
Try inserting a pry bar or equiv. in space A, bet... May 17 2015, 03:33 AM pilothyer After you get it off, the handle can be restored a... May 16 2015, 01:20 PM URY914
After you get it off, the handle can be restored ... May 17 2015, 03:31 AM jacksun thank you for your reply....
I am thinking that I... May 16 2015, 01:21 PM URY914 I know more about outside door handles than anyone... May 17 2015, 03:29 AM jacksun so......... what I did was to cut off the nut and... May 17 2015, 05:17 AM  |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 05:12 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.