Pertronix Ignitor install on 2.7 conversion, couple of questions... |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Pertronix Ignitor install on 2.7 conversion, couple of questions... |
Ferg |
Sep 10 2004, 08:30 AM
Post
#1
|
914 Guru Group: Members Posts: 5,948 Joined: 8-January 03 From: Boulder CO Member No.: 116 Region Association: None |
So two things I need to find out to finish this install...
1. What is a good switched 12v power source for the red wire? One that is close by the distributor and coil? 2. I took my bosh coil off, to test ohms and only got .6, the instructions say i need 1.5 ohms so I think i need a new coil. what kind? Oil or epoxy, Is pertronix flamethrower coil the way to go? Thanks Ferg. |
lapuwali |
Sep 10 2004, 10:52 AM
Post
#2
|
Not another one! Group: Benefactors Posts: 4,526 Joined: 1-March 04 From: San Mateo, CA Member No.: 1,743 |
Coils are either internally or externally "ballasted". Either the resistance is in the coil itself (true for the typical "Bosch Blue", for example), or is an external resistor. If your coil only measures 0.6 ohms with no external wires attached, it's not internally ballasted. If it were, you would see 1.5 ohms or more across the side posts (probably something like 3 ohms). Since there's no internal ballast, there's probably an external one, either an actual resistor, or just a high-resistance wire. Either of these will be between the + post on the coil and whatever it connects to (eventually, it will reach the ignition switch, but it probably hits a fuse first, and may hit some internal connector first).
If there's no obvious box there (ballast resistors are large) connected to the coil, then it's probably in the wire itself. Try tracing that wire to it's other end, and measure the resistance across it. If there is very little resistance (that is, if the resistance in the wire/resistor and the coil both add up to less than 1.5ohms), then your ignition system has no ballast at all. If so, you'll either need to get an internally ballasted coil, or an external ballast resistor. If there IS enough resistance through that wire, then you need to hook up the Pertronix red wire to the far end (not the coil end) of that wire. |
Lo-Fi Version | Time is now: 26th September 2024 - 12:14 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |