 Front Torsion Bar Installation |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| EPK |
 Sep 11 2004, 11:17 AM
Post
#1
|
|
Newbie  Group: Members Posts: 20 Joined: 26-May 03 From: Victoria B.C Member No.: 740  |
According to the 914 factory workshop manual when installing the front torsion bars the a-arm is pulled down with a pry bar to acheive what appears to be full "droop". I'm assuming this is to pre-load the torsion bar correctly once the ajuster is installed. Once this is done and the car is lowered with the wheels now on how much adjustment height (up and down) is possible. If for example after doing this you can't raise or lower it enough what is the correct way to correct the problem because the bar has already been pre-tensioned with the pry bar as mentioned.
|
   |
 
|
Posts in this topic
  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 02:08 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.