 Drilling for 10mm Roll Pins On New CV Joint., Use a drill bit or have it machined out. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| tach |
 Sep 6 2015, 12:56 PM
Post
#1
|
|
Member  Group: Members Posts: 79 Joined: 6-November 09 From: Minnesota Member No.: 11,016 Region Association: Upper MidWest  |
I ordered new VW type 1 lobro cv joints for my 914 but the 2 roll pin holes need to be bored out to 10mm X 20mm deep. I was wondering if I can just bore out the hole on my drill press with a 10mm drill bit or do I need to have the hole machine larger with a end mill by a machine shop?
|
   |
 
|
  |
Replies
| 914Sixer |
Sep 6 2015, 07:41 PM
Post
#2
|
|
914 Guru Group: Members Posts: 8,920 Joined: 17-January 05 From: San Angelo Texas Member No.: 3,457 Region Association: Southwest Region 
|
Complete new axles are available from Porsche. They are under $300 depending on which Porsche dealer you find on line.
|
|
|
|
Posts in this topic
tach Drilling for 10mm Roll Pins On New CV Joint. Sep 6 2015, 12:56 PM
914_teener
I ordered new VW cv joints for my 914 but the 2 r... Sep 6 2015, 01:42 PM
tach
I ordered new VW cv joints for my 914 but the 2 ... Sep 6 2015, 02:10 PM The Cabinetmaker I have used a drill press with good results. Find ... Sep 6 2015, 01:48 PM tach
I have used a drill press with good results. Find... Sep 6 2015, 02:11 PM Mueller
I ordered new VW cv joints for my 914 but the 2 r... Sep 6 2015, 02:12 PM The Cabinetmaker BTW, please use all drill press safety procedures.... Sep 6 2015, 02:22 PM Chris H. FYI these are pre-drilled for 10mm roll pins and a... Sep 6 2015, 10:48 PM Downunderman Has anyone just drilled the two roll pin holes and... Sep 7 2015, 01:18 PM 914Mike
Has anyone just drilled the two roll pin holes an... Sep 7 2015, 05:43 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 25th June 2024 - 08:17 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.