 Engine cover weak opening, Torsion rod tightening |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| oakdalecurtis |
 Jul 25 2016, 03:28 PM
Post
#1
|
|
Oakdalecurtis  Group: Members Posts: 1,346 Joined: 5-June 15 From: Oakdale, Ca Member No.: 18,802 Region Association: Central California 
 |
If your engine cover opens weakly with not enough torsion spring power, here's a simple and easy fix. Just take a one inch section of half inch diameter delron rod and drill a quarter inch hole through it. Then pry the end of the torsion bar up with a screwdriver and slide the plastic tube on it. The tension on the rod will keep the spacer in place, and you can sequentially add up to four spacers total, one on each end of both rods maximum. That way you can increase opening power as you add each spacer and decide when it's opening power is just right. This picture shows you the plan.
 |
   |
 
|
Posts in this topic
worn
If your engine cover opens weakly with not enough... Jul 25 2016, 04:04 PM
oakdalecurtis
If your engine cover opens weakly with not enoug... Jul 25 2016, 05:12 PM whitetwinturbo :worship: :worship: :worship: Jul 25 2016, 09:23 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th December 2024 - 06:39 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.