 Rear brake disk retaining screws for drilled 5 lug hubs |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| tornik550 |
 Jul 26 2016, 05:10 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,248 Joined: 29-January 07 From: Ohio Member No.: 7,486 Region Association: None  |
On the rear of my 914, I have 4 lug hubs drilled to 5 lugs. I have sebro rear disks.
I was going to install them however when the hubs were drilled, now the M6 disk retaining screws do not line up. Are these necessary? Should I just drill and tap the holes for the retaining screws? |
   |
 
|
  |
Replies
| tornik550 |
Jul 26 2016, 05:30 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,248 Joined: 29-January 07 From: Ohio Member No.: 7,486 Region Association: None |
Sorry for my poor explanation. I have 914/4 hubs that were drilled for 5 lugs. Now that they are converted to 5 lug hubs- the brake disk retaining screw holes on the brake disk do not align with the tapped holes on the hub.
In the first picture- the A-holes do not line up with the b-holes in picture 2. The question is- is there an alternative or do I simply have to drill and tap new holes in the hub? Attached thumbnail(s) 
|
|
|
|
Posts in this topic
tornik550 Rear brake disk retaining screws for drilled 5 lug hubs Jul 26 2016, 05:10 PM
914Sixer I guess I am confused, did you drill the rotors to... Jul 26 2016, 05:17 PM tornik550 :D Jul 26 2016, 05:31 PM wndsnd Why cant you just rotate it? Jul 26 2016, 05:32 PM
tornik550
Why cant you just rotate it?
I did rotate it. ... Jul 26 2016, 05:33 PM tornik550 Soooo my a-hole doesn't line up with my b-hole... Jul 26 2016, 05:33 PM Krieger Thats your problem. Your car has four A holes... Jul 26 2016, 05:38 PM ConeDodger I think, you have to drill and tap a new hole. Whi... Jul 26 2016, 05:43 PM wndsrfr
I think, you have to drill and tap a new hole. Wh... Jul 26 2016, 05:47 PM BillC The retaining screws are not needed. They are jus... Jul 26 2016, 05:50 PM tornik550 Perfect. I could see how those little M6 screws ... Jul 26 2016, 05:55 PM Spoke The securing holes on 911 rotors do not match up w... Jul 27 2016, 07:47 AM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th January 2025 - 06:35 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.