 OT...Adhesive/glue for plastic, Wagner paint sprayer |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Porschef |
 Oct 4 2016, 07:06 PM
Post
#1
|
|
How you doin'  Group: Members Posts: 2,180 Joined: 7-September 10 From: LawnGuyland Member No.: 12,152 Region Association: North East States 
 |
So the tool abusers have handed off another patient, a Wagner 91460s
(does that count as Porsche topic? (IMG:style_emoticons/default/rolleyes.gif) )...anyway, I opened it up to find that the pressure switch housing has broken, thus not allowing the unit to shut off, and build too much pressure. I think that may have affected the prime valve, but that's not for certain. Anyway, has anyone got a solid suggestion for an (unknown) plastic glue? The back of the adjustment stem does get captured in the rear housing, so I think that takes most of the stress. I've got epoxy, model glue, JB Weld kicking around but I'd like to get a one and some thing going. TIA, Joe |
   |
 
|
  |
Replies
| Valy |
Oct 4 2016, 07:23 PM
Post
#2
|
|
Senior Member Group: Members Posts: 1,677 Joined: 6-April 10 From: Sunnyvale, CA Member No.: 11,573 Region Association: Northern California |
Epoxy is not good for plastic. The model glue is good only for certain plastics.
What I recommend is the following: 1. Use some steel wire to secure the pieces if possible. 2. Use superglue (the instant glue that glues everything in 5sec) and baking soda. You build a support structure around what's broken to increase the contact surface. Put a bit of glue and then add some powder. Then remove the excess powder and add more glue and more powder unitl you're.satisfied. The result is a very hard polymer that you can file and paint if needed. |
|
|
|
Posts in this topic
Porschef OT...Adhesive/glue for plastic Oct 4 2016, 07:06 PM
Porschef Interesting. Thanks, I'll give it a try. Would... Oct 4 2016, 07:47 PM Valy In this case I would just make 2 wire stitches. I ... Oct 4 2016, 07:59 PM Mike Bellis This stuff is awesome and will bond almost any pla... Oct 4 2016, 09:41 PM Chris914n6 White plastic... that's bad, specially if it... Oct 4 2016, 09:50 PM
Valy Here is an example of something similar. The left ... Oct 4 2016, 10:11 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th January 2025 - 05:41 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.