 does anyone have a roller in northern va?, i need to test fit an engine cradle. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jimkelly |
 Jun 21 2017, 06:48 AM
Post
#1
|
|
Delaware USA  Group: Members Posts: 4,969 Joined: 5-August 04 From: Delaware, USA Member No.: 2,460 Region Association: MidAtlantic Region  |
i need to text fit this suby engine/trans cradle so i can determine where to place the trans hanger sections and orient it properly.
Attached thumbnail(s) 
|
   |
 
|
  |
Replies
| jimkelly |
Jun 22 2017, 11:26 AM
Post
#2
|
|
Delaware USA Group: Members Posts: 4,969 Joined: 5-August 04 From: Delaware, USA Member No.: 2,460 Region Association: MidAtlantic Region |
got wooden jig set up for get rear mount points in place.
once i get this tacked up, i will take over to rob's to see how it fits to car. i did have to hog out the front mount holes about a 1/4 inch outward on both, this is because my cross bar was a bit short and i had to weld a decent gap which must have pulled the whole cradle tight inward. Attached thumbnail(s) 
|
|
|
|
Posts in this topic
jimkelly does anyone have a roller in northern va? Jun 21 2017, 06:48 AM
BeatNavy Jim, I've got a '75 body up on a cart in m... Jun 21 2017, 06:59 AM jimkelly rob, of course, thanks.
all the crazy avatars and... Jun 21 2017, 08:05 AM
BeatNavy
does your car have engine and trans mounts instal... Jun 21 2017, 09:18 AM jimkelly hum, should be still doable.
sample pic from unde... Jun 21 2017, 11:37 AM jimkelly working on a jig. Jun 21 2017, 08:41 PM jimkelly pic Jun 22 2017, 05:17 PM BeatNavy Looks good, Jim. My tub will be excited to be use... Jun 22 2017, 06:42 PM jimkelly looks good though i wish it were DEAD NUTS/SPOT ON... Jun 22 2017, 06:55 PM BeatNavy
looks good though i wish it were DEAD NUTS/SPOT O... Jun 22 2017, 07:05 PM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th January 2025 - 06:38 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.