 holes in longs, how to mend these? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 914 RZ-1 |
 Sep 9 2017, 06:05 PM
Post
#1
|
|
Porsche Padawan  Group: Members Posts: 683 Joined: 17-December 14 From: Santa Clarita, CA Member No.: 18,230 Region Association: Southern California  |
I took off my rocker panels and found a huge pile of dirt around the jack hole. After cleaning it, I found 4 small holes in the driver's side.
How should these be patched: weld a rectangular piece over the hole (or all 4 of them) OR weld a piece flush in each hole? Or does it even matter? I will have to take it to a place, so I'm assuming I can drive the car without rocker panels, correct?  |
   |
 
|
  |
Replies
| PlantMan |
Sep 9 2017, 06:32 PM
Post
#2
|
|
Member Group: Members Posts: 438 Joined: 14-May 14 From: Mission Viejo Member No.: 17,352 Region Association: Southern California |
If it was in an accident that would explain a few things.
|
|
|
|
Posts in this topic
914 RZ-1 holes in longs Sep 9 2017, 06:05 PM
rhodyguy Take off the loose material to the right of the ho... Sep 9 2017, 06:16 PM
914 RZ-1
Take off the loose material to the right of the h... Sep 9 2017, 06:22 PM PlantMan
I took off my rocker panels and found a huge pile... Sep 9 2017, 06:18 PM 914 RZ-1 Those are very interesting holes.....
It almost lo... Sep 9 2017, 06:27 PM Chris914n6 Not a normal place for factory undercoating. I... Sep 9 2017, 06:32 PM SirAndy Looks to be repaired, questionably....
:agree:
... Sep 10 2017, 07:34 PM Andyrew I would start wire wheeling that area and the area... Sep 10 2017, 07:41 PM Mblizzard I have a similar poor repair that is not rusted bu... Sep 11 2017, 10:51 AM 914 RZ-1 Here's a picture of the area after I cleaned o... Sep 16 2017, 01:07 PM live free & drive Maybe your car was treated for rust by Zeibart - t... Sep 16 2017, 01:28 PM injunmort fwiw, i would cut from sill support to after jack ... Sep 16 2017, 06:38 PM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 04:40 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.