 compression numbers, how bad are these |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| mobymutt |
 Oct 8 2017, 06:46 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 553 Joined: 16-December 13 From: Kingston, Ontario, Canada Member No.: 16,770 Region Association: Canada  |
Just did a compression check, here's what I measured:
108, 120, 96, 85 I've got a stock 1.8L, but would like to build a 1911 or 2056 in the relatively near future. Hopefully I'll be ok for another year or so with the current setup. |
   |
 
|
  |
Replies
| mobymutt |
Oct 8 2017, 08:31 AM
Post
#2
|
|
Senior Member Group: Members Posts: 553 Joined: 16-December 13 From: Kingston, Ontario, Canada Member No.: 16,770 Region Association: Canada |
Full disclosure: I did just have the engine apart, but (for a number of reasons) I didn't replace the pistons, cylinders or rings.
There was actually a pretty big 'pocket' in one of the cylinder walls (looked like a casting void), so having at least one cylinder with low compression doesn't surprise me. Is there an actual spec for what the compression numbers should be on a good engine? |
|
|
|
Posts in this topic
mobymutt compression numbers Oct 8 2017, 06:46 AM
914Sixer Looks like time to rebuild. Go for the 2056. Oct 8 2017, 07:02 AM DM_2000 Do a leak down test, that wil let you know where t... Oct 8 2017, 07:13 AM rgalla9146 A leakdown test should be done as well. It will gi... Oct 8 2017, 07:48 AM
malcolm2
The compression test should be done after a p... Oct 8 2017, 04:14 PM rgalla9146
Full disclosure: I did just have the engine apart... Oct 8 2017, 09:11 AM Morrie
Full disclosure: I did just have the engine apar... Oct 8 2017, 10:56 AM porschetub
Full disclosure: I did just have the engine apart... Oct 8 2017, 01:53 PM cuddyk If you separated the pistons and jugs and didn... Oct 8 2017, 02:27 PM DM_2000 I don't do the often repeated "add oil to... Oct 8 2017, 04:05 PM mobymutt Thanks to all for the responses (and patience, as ... Oct 8 2017, 04:17 PM Mark Henry Start saving some coin Matt, likely there's go... Oct 8 2017, 05:17 PM mobymutt
Start saving some coin Matt, likely there's g... Oct 8 2017, 06:42 PM injunmort consider the tangine racing cable set up rather th... Oct 8 2017, 05:23 PM mobymutt
consider the tangine racing cable set up rather t... Oct 8 2017, 06:39 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th December 2024 - 12:13 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.