 Thermo Switch Location, Wiring on 1.7L D-Jet Not connected |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 1adam12 |
 Oct 14 2017, 04:45 PM
Post
#1
|
|
Member  Group: Members Posts: 209 Joined: 25-May 17 From: Chino Hills, CA Member No.: 21,132 Region Association: Southern California  |
I read on another post that the Thermo Switch may not be an issue if it's not wired up. I'm going through my wire harness and found that the wire for the Thermo Switch is cut. Can anyone tell me where the location of the switch is and does the wire use a spade connector to mount on the switch?
|
   |
 
|
  |
Replies
| 914_teener |
Oct 14 2017, 05:00 PM
Post
#2
|
|
914 Guru Group: Members Posts: 5,250 Joined: 31-August 08 From: So. Cal Member No.: 9,489 Region Association: Southern California |
Adam,
It is underneath the manifold and opens the Cold Start Valve. It only works when the temperature is under 32 deg. I seriously recommend if you have broken ground leads or they are brittle is to check your MPS, save your money and get a harness from Jeff Bowlsby. It will be the best investment you can make. Ya could be chasing your tail for a while. Most of the problems are with electrical grounds on these cars with the stock FI. Check the MPS for leaks and then the grounds. Including the one inside the distributor. Do that first and then check back. |
|
|
|
Posts in this topic
1adam12 Thermo Switch Location Oct 14 2017, 04:45 PM
1adam12
Adam,
It is underneath the manifold and opens th... Oct 14 2017, 07:19 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th December 2024 - 07:12 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.