Main Chasis Wiring Harness, Does anyone on the board make them? Options

[mmichalik]

Hi everyone,

I've already purchased the ignition and alternator harness from Jeff Bolwsby, along with the oil pressure cable so, from an engine bay perspective, I'm covered.

But, I don't think Jeff makes the main chassis harness.

George Hussey gave me a source for one but, before I go outside for it, I wanted to see if anyone here on the board makes them or has a good source for them.

Any suggestions would be appreciated. I would like to keep it all in the family if I can. If not, I'm sure Mr. Hussey's recommendation will take care of me or I will find a local auto electric shop for it.

Thanks,

Mike

[dr914@autoatlanta.com]

usually the harnesses are quite good, and unless someone has butchered it or had a fire or mice rat damage has occurred, the harness can easily be repaired. It is hard to remove unless the car is stripped as well, so my best recommendation is to repair yours. As previously mentioned, you can buy a used harness very reasonably to be able to have all of the proper colored and sized and ended wires to splice solder and heatshrink repair connections