 Axles or Just Stubs?, for a roller - what would you do? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bbrock |
 Jun 22 2019, 10:10 AM
Post
#1
|
|
914 Guru  Group: Members Posts: 5,269 Joined: 17-February 17 From: Montana Member No.: 20,845 Region Association: Rocky Mountains 
 |
I've got just a few things left to do before pulling my car off the rotisserie and making it a roller. One of them is installing and torquing the rear axle stubs so as not to wreck my new bearings. The car will be a roller with no engine or trans for the next few months. I go back and forth about which would be better - bolt the axles onto the stubs before they go in, or install stubs only for now and bolt the axles in later. It's been decades since I installed an axle with the stub in the car and don't remember how much of a PITA it is compared to the PITA of dealing with loose inner axle ends while the car is a roller without transmission installed. What's your preference?
|
   |
 
|
  |
Replies
| 914werke |
Jun 22 2019, 03:08 PM
Post
#2
|
|
"I got blisters on me fingers" Group: Members Posts: 11,022 Joined: 22-March 03 From: USofA Member No.: 453 Region Association: Pacific Northwest
|
No question, stubs! As stated, no need to torque them
|
|
|
|
Posts in this topic
bbrock Axles or Just Stubs? Jun 22 2019, 10:10 AM
dlee6204 I’d go ahead and bolt the axles in while it’s ... Jun 22 2019, 10:20 AM IronHillRestorations I'd put the hubs and stubs, but not torque the... Jun 22 2019, 11:02 AM jcd914 I would just install the stubs.
I don't like r... Jun 22 2019, 11:17 AM tejon007 Depending on how much rolling around you'll be... Jun 22 2019, 12:00 PM Rand Isn't the issue that hasn't been stated ye... Jun 22 2019, 01:14 PM
Superhawk996
No question, stubs! As stated, no need to tor... Jun 22 2019, 05:48 PM bbrock This is all great feedback and some good ideas. I... Jun 22 2019, 04:38 PM 914forme I have an extra set of -4 stubs that will not fit ... Jun 22 2019, 05:11 PM rgalla9146 Put only the stubs in and tighten with a breaker b... Jun 22 2019, 06:07 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 22nd December 2024 - 01:16 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.