 Lost my bearings, RWL bearings |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jwalters |
  Dec 2 2004, 05:04 PM
Post
#1
|
|
Sooo Close.......  Group: Members Posts: 1,677 Joined: 14-May 04 From: Huntsville, AL Member No.: 2,068 Region Association: Europe  |
(IMG:style_emoticons/default/ohmy.gif) Need some input please. When I replaced my rwl bearings on my daily driver, they were from pep-boys, do not remember the brand but was U.S.A. They went in w/o a hitch, and when torqued had what I thouroughly believed as beautiful feeling pre-load. No noises when turned, easy to turn w/ some resistance--now those are not bothering me, this is:
When I got my spare (rear) arms built up, I had gotten some more new bearings (SKF brand , made in Spain) for my rebuild project. Now, I am not quite sure about them, and it sickens me (IMG:style_emoticons/default/icon8.gif) (IMG:style_emoticons/default/barf.gif) that they may have to be replaced before I even use them. See, these have little pre-load on them at all, and when I spin the hub, they emit a sound as if there is no grease in them. I loosened the nuts and double checked the torques-- (IMG:style_emoticons/default/confused24.gif) Has anybody else faced this before??? I have never in my 20+ years of wrenching come across a situation such as this. Two brand new bearings, not feeling bad, but not quite right either..... |
   |
 
|
  |
Replies
| jwalters |
Dec 2 2004, 06:41 PM
Post
#2
|
|
Sooo Close....... Group: Members Posts: 1,677 Joined: 14-May 04 From: Huntsville, AL Member No.: 2,068 Region Association: Europe |
(IMG:style_emoticons/default/wink.gif) By gosh I hope not--it is bad juju enough to deal with getting that half shell of the hub without tearing up the mating surface---
|
|
|
|
Posts in this topic
jwalters Lost my bearings Dec 2 2004, 05:04 PM
jwalters :o By the way, I am really just curious if this i... Dec 2 2004, 05:40 PM silver2.0 I guess I don't fully understand the problem, ... Dec 2 2004, 06:19 PM jwalters :o no no no, it was sealed in its plastic and car... Dec 2 2004, 06:27 PM MattR SKF is one of the big names in bearings for these ... Dec 2 2004, 06:37 PM rick 918-S I remember a topic on this subject a while back. D... Dec 2 2004, 07:54 PM JOHNMAN Here is my $0.02....
If in doubt, get anothe... Dec 2 2004, 10:06 PM
jwalters ;) Yea, I went out there again last night, turned... Dec 3 2004, 08:54 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st October 2024 - 09:32 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.