 Powder coat epoxy primer from PPG, Heard of this? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| TravisNeff |
 Nov 25 2019, 08:24 PM
Post
#1
|
|
914 Guru  Group: Members Posts: 5,082 Joined: 20-March 03 From: Mesa, AZ Member No.: 447 Region Association: Southwest Region 
 |
I am looking around local shops to blast my 914, I saw that they offered Epoxy priming as part of the service - Turns out it is a powder coat epoxy product from PPG.
Has anyone heard of this? The spec sheet from PPG is a little ambiguous for top coats. PCMT70101 ENVIROCRON® Powder Coat http://www.azprostrip.com/epoxy-primer/ |
   |
 
|
  |
Replies
| sixnotfour |
Nov 25 2019, 09:07 PM
Post
#2
|
|
914 Wizard Group: Members Posts: 10,681 Joined: 12-September 04 From: Life Elevated..planet UT. Member No.: 2,744 Region Association: Rocky Mountains 
|
QUOTE(TravisNeff @ Nov 25 2019, 07:24 PM)  I am looking around local shops to blast my 914, I saw that they offered Epoxy priming as part of the service - Turns out it is a powder coat epoxy product from PPG. Has anyone heard of this? The spec sheet from PPG is a little ambiguous for top coats. PCMT70101 ENVIROCRON® Powder Coat http://www.azprostrip.com/epoxy-primer/ interior // temp of bake ? ...good for stripped shells but ?? i had my shell sprayed and baked ,,but had the body shop spray the epoxy..10 yrs ago.. |
|
|
|
Posts in this topic
TravisNeff Powder coat epoxy primer from PPG Nov 25 2019, 08:24 PM
mepstein Looks like it's low temp (350 degrees) powder ... Nov 25 2019, 09:30 PM Mark Henry I'd ask if it's easy to sand off if you ha... Nov 25 2019, 10:06 PM
mepstein
I'd ask if it's easy to sand off if you h... Nov 25 2019, 10:09 PM Boothy May not be the same but I sprayed my 356 with an e... Nov 26 2019, 05:56 AM jmitro yea there's epoxy primer and then there's ... Nov 26 2019, 09:49 AM Andyrew Sounds like the start of a $20k paint job. Nov 26 2019, 10:10 AM TravisNeff Spec sheet. Nov 26 2019, 10:22 AM TravisNeff I called the shop and asked a couple of questions.... Nov 26 2019, 11:22 AM Andyrew
I called the shop and asked a couple of questions... Nov 26 2019, 11:29 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 12:57 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.