 Powder coat epoxy primer from PPG, Heard of this? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| TravisNeff |
 Nov 25 2019, 08:24 PM
Post
#1
|
|
914 Guru  Group: Members Posts: 5,082 Joined: 20-March 03 From: Mesa, AZ Member No.: 447 Region Association: Southwest Region 
 |
I am looking around local shops to blast my 914, I saw that they offered Epoxy priming as part of the service - Turns out it is a powder coat epoxy product from PPG.
Has anyone heard of this? The spec sheet from PPG is a little ambiguous for top coats. PCMT70101 ENVIROCRON® Powder Coat http://www.azprostrip.com/epoxy-primer/ |
   |
 
|
  |
Replies
| TravisNeff |
Nov 26 2019, 11:22 AM
Post
#2
|
|
914 Guru Group: Members Posts: 5,082 Joined: 20-March 03 From: Mesa, AZ Member No.: 447 Region Association: Southwest Region
|
I called the shop and asked a couple of questions. They say that it is compatible to topcoat with any other PPG products, high build primers etc.
Ballpark prices were $1,100 for the shell if I get most of the seam sealer out. $125 for each door and if I did the decklids too it would be around $1600 total with media blast, de-ionizing and powder epoxy. Sounds about the same price for media and traditional epoxy spray application? |
|
|
|
Posts in this topic
TravisNeff Powder coat epoxy primer from PPG Nov 25 2019, 08:24 PM
sixnotfour
I am looking around local shops to blast my 914, ... Nov 25 2019, 09:07 PM mepstein Looks like it's low temp (350 degrees) powder ... Nov 25 2019, 09:30 PM Mark Henry I'd ask if it's easy to sand off if you ha... Nov 25 2019, 10:06 PM
mepstein
I'd ask if it's easy to sand off if you h... Nov 25 2019, 10:09 PM Boothy May not be the same but I sprayed my 356 with an e... Nov 26 2019, 05:56 AM jmitro yea there's epoxy primer and then there's ... Nov 26 2019, 09:49 AM Andyrew Sounds like the start of a $20k paint job. Nov 26 2019, 10:10 AM TravisNeff Spec sheet. Nov 26 2019, 10:22 AM Andyrew
I called the shop and asked a couple of questions... Nov 26 2019, 11:29 AM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 01:04 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.