 Best Piston Ring Compressor Tool, For my 2.0 Liter Type IV Motor |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| motorvated |
 Dec 19 2019, 12:22 PM
Post
#1
|
|
Member  Group: Members Posts: 282 Joined: 13-February 13 From: Colorado Member No.: 15,519 Region Association: Rocky Mountains  |
Any recommendations for a good piston ring compression tool that I can use on my 2.0 and 1.8 liter Type IV motors? I've had a couple of them and neither has worked very well on other applications, and the one I now have is giving me problems getting the pistons back into the cylinders with the new rings in place on the 2.0 liter motor.
|
   |
 
|
  |
Replies
| roblav1 |
Dec 19 2019, 06:25 PM
Post
#2
|
|
Senior Member Group: Members Posts: 528 Joined: 18-September 12 From: KY Member No.: 14,943 Region Association: MidAtlantic Region |
I've always made them out of .060 aluminum, with two bends, with those bends held together by vice grips. I have no vices, but I do have about 6 or 7 of these I've made over the years of rebuilds.
Lots of lube is the key. |
|
|
|
Posts in this topic
motorvated Best Piston Ring Compressor Tool Dec 19 2019, 12:22 PM
cuddy_k They all work pretty much the same. The trick is u... Dec 19 2019, 12:42 PM Superhawk996 Are you yanking my chain? We just had this discus... Dec 19 2019, 01:12 PM Mark Henry
Any recommendations for a good piston ring compre... Dec 19 2019, 04:34 PM
motorvated
Any recommendations for a good piston ring compr... Dec 19 2019, 06:18 PM Mark Henry
I've always made them out of .060 aluminum, w... Dec 19 2019, 08:29 PM injunmort I have had the best luck with this, have used the ... Dec 19 2019, 06:53 PM rgalla9146 Complicated and simple.
Both work.
The Hazet... Dec 19 2019, 08:04 PM Mark Henry I have a bunch of the top ones for T1 and 356, I... Dec 19 2019, 08:17 PM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 09:50 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.