 Targa Top Reaar Seal Fit, What is the fuzzy suppose to rest on? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Highland |
 Feb 16 2020, 12:20 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 529 Joined: 8-August 11 From: San Diego, CA Member No.: 13,418 Region Association: Southern California  |
Is the rear targa top seal fuzzy designed to rest on top of the side and rear aluminum trim?
I decided not to install the roll bar vinyl, so am a little concerned I might scratch the paint with the seal mounting screws. I also noticed a fair amount of targa top flexing while test fitting. Is the top designed to be a "spring" so there is tension against the hold down mechanism? |
   |
 
|
  |
Replies
| Mikey914 |
Feb 16 2020, 03:39 AM
Post
#2
|
|
The rubber man Group: Members Posts: 12,741 Joined: 27-December 04 From: Hillsboro, OR Member No.: 3,348 Region Association: None 
|
The fuzzy sits on the aluminum bar on the back and the side strips. Not any painted surface. You can see some wear on both surfaces. There is some tension against the rubber blocks on the roof where the hook catches. This is where you could have an issue.
|
|
|
|
Posts in this topic
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 04:59 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.