Vinyl Wrapping a 914 with GT Flares, Deck lids and doors finished. Options

[poorsche914]

Been planning on wrapping my 914 with printed vinyl for several months. Had a mockup of the design finished this past winter. Finally built the full-size graphics and began printing the vinyl today. I have experience wrapping flat surfaces such as walls and enclosed trailers so the doors and deck lids on the 914 should be a breeze.

However... the flares are going to be a challenge. I have decided to do a color layer first and then add the graphic elements separately (the doors and deck lids have base layer and graphics printed as one).

Any tips on how to best apply the wrap to the flares without ending up with a wrinkly mess would be greatly appreciated.

steve
(IMG:style_emoticons/default/driving.gif)

[mepstein]

The video I watched said not to heat. You are building in tension that eventually wants to go back to the original relaxed state. I think doing some practice pieces is a good idea.

[burton73]

The video I watched said not to heat. You are building in tension that eventually wants to go back to the original relaxed state. I think doing some practice pieces is a good idea.

I remember looking at a UTube on wrapping technique. This guy was very good with a cold stretch tech

Bob B

https://www.youtube.com/watch?v=aU8f8pi06Hs

[poorsche914]

I remember looking at a UTube on wrapping technique. This guy was very good with a cold stretch tech

Bob B

https://www.youtube.com/watch?v=aU8f8pi06Hs

Thanks for that, Bob. I've actually watched that video a couple times and several other videos by that guy. He is very good!

He has a video where he wraps a truck in gold chrome. The fenders have similar complex curves but, unfortunately, the video is a time lapse so can't really see the technique (IMG:style_emoticons/default/dry.gif)

I'll end up doing a trial or two with plain vinyl to get a feel for how the vinyl lays before trying it with printed vinyl.

(IMG:style_emoticons/default/driving.gif)

[KELTY360]

I remember looking at a UTube on wrapping technique. This guy was very good with a cold stretch tech

Bob B

https://www.youtube.com/watch?v=aU8f8pi06Hs

Thanks for that, Bob. I've actually watched that video a couple times and several other videos by that guy. He is very good!

He has a video where he wraps a truck in gold chrome. The fenders have similar complex curves but, unfortunately, the video is a time lapse so can't really see the technique (IMG:style_emoticons/default/dry.gif)

I'll end up doing a trial or two with plain vinyl to get a feel for how the vinyl lays before trying it with printed vinyl.

(IMG:style_emoticons/default/driving.gif)

Why not try contacting the guy that did the video and ask for specific advise to your application? Good luck with the project, looking forward to seeing the graphics.