 71 Fiberglass Rear Valence (w/hole) from AutoAtlanta, How to cut fiberglass? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| boxster914 |
 Oct 1 2020, 04:56 PM
Post
#1
|
|
Member  Group: Members Posts: 77 Joined: 17-September 20 From: NC, USA Member No.: 24,700 Region Association: South East States  |
Hi everyone I am very excited to take my Irish (forest) Green 71 currently with ridiculous Monza exhaust back to stock.
 I have a Dansk muffler on order but I need to sort the valence. Has anyone had any experience with the AutoAtlanta fiberglass rear valence? http://www.autoatlanta.com/Porsche-Fibergl...N-RMIT1412.html I know the hole is not precut but is it marked on the inside of the piece where to cut the hole? If it is, how do you cut fiberglass? If not, how do you figure out where to cut the hole? The early valences with the hole are hard to find and very expensive if you can find one so this seems like a good alternative assuming the hole cutting process is not too complex. As always, any advice is welcome. |
   |
 
|
  |
Replies
| partsman912 |
Oct 1 2020, 08:26 PM
Post
#2
|
|
Newbie Group: Members Posts: 7 Joined: 29-March 20 From: Maryland Member No.: 24,076 Region Association: MidAtlantic Region |
I have a factory steel rear valance with hole .
PM me if you are interested. |
|
|
|
Posts in this topic
boxster914 71 Fiberglass Rear Valence (w/hole) from AutoAtlanta Oct 1 2020, 04:56 PM
douglastic ". . . WITH HOLE (HOLE NOT CUT)"
Everyt... Oct 1 2020, 05:11 PM gms a hole saw or a reciprocating saw should do the tr... Oct 1 2020, 06:21 PM Mikey914 If your going stock, I can hook you up with the st... Oct 1 2020, 08:47 PM
gms
If your going stock, I can hook you up with the s... Oct 1 2020, 09:28 PM VegasRacer If you cut it yourself you end up with just a hole... Oct 1 2020, 09:42 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 22nd December 2024 - 01:47 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.