Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Splitting Impeller housing, Update: tins and flaps with headers?
rfinegan
post Jul 26 2021, 02:51 PM
Post #1


Senior Member
***

Group: Members
Posts: 1,042
Joined: 8-February 13
From: NC
Member No.: 15,499
Region Association: MidAtlantic Region



I have my impeller house apart for cleaning and it appears there were alignment pins for the front and back halves . How many are there? I have 2 pins around the impeller itself. There seems to be holes in the perimeter for pins too? Please review and advise so I can dig up some more as needed

Best

Robert

Diagram does not show the housing in 2 pieces

Attached Image
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
rfinegan
post Jul 27 2021, 04:20 AM
Post #2


Senior Member
***

Group: Members
Posts: 1,042
Joined: 8-February 13
From: NC
Member No.: 15,499
Region Association: MidAtlantic Region



What are people in the "914 Word" doing with cars with no heat and headers?
(NOT the Thermostat Flaps) But I do have to relocate my stat away from the headers.
NO lower tins?
What about the flaps on the impeller housing? The little pins will fall out
Anyone block this off for more flow around the heads and cylinders ?

Or just let them BLOW
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
4 User(s) are reading this topic (4 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 8th January 2025 - 12:54 AM