Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Splitting Impeller housing, Update: tins and flaps with headers?
rfinegan
post Jul 26 2021, 02:51 PM
Post #1


Senior Member
***

Group: Members
Posts: 1,042
Joined: 8-February 13
From: NC
Member No.: 15,499
Region Association: MidAtlantic Region



I have my impeller house apart for cleaning and it appears there were alignment pins for the front and back halves . How many are there? I have 2 pins around the impeller itself. There seems to be holes in the perimeter for pins too? Please review and advise so I can dig up some more as needed

Best

Robert

Diagram does not show the housing in 2 pieces

Attached Image
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
Nogoodwithusernames
post Jul 28 2021, 01:55 PM
Post #2


Member
**

Group: Members
Posts: 277
Joined: 31-May 16
From: Sutter, CA
Member No.: 20,051
Region Association: None



I've been told that Jake Raby does not block off the little heater outlets. His testing showed that it caused turbulent air in the fan housing decreasing cooling ability.

I've not seen the original thread where he says that so take it second or third hand but I am running with no block off.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
14 User(s) are reading this topic (14 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 8th January 2025 - 01:12 AM