Replacement Fuel Injectors, Have an injector leaking |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Replacement Fuel Injectors, Have an injector leaking |
SteveL |
Aug 12 2021, 02:46 PM
Post
#1
|
Senior Member Group: Members Posts: 663 Joined: 7-August 03 From: Andover, MN Member No.: 991 Region Association: None |
So, I hooked up my brand new HF fuel pressure gauge (thanks for the tip at $19).
Sure enough, starts, runs fine for a minute, starts missing, fuel pressure drops, engine dies as pressure gets under 20lbs. Wait a minute, engine starts back up, repeat cycle. All of a sudden, I see a spray of fuel coming from injector #1. Can't really tell if it is coming from the short hose from fuel rail to injector or the injector seal. I assume that I caused this problem while moving the fuel rail around when hooking up the pressure gauge to the test port. The only way to make it leak is to put everything back, but then there is too much stuff in the way to see where it is leaking. The injectors have been replaced by me in the past, but it has been over 15 years. Should I just bite the bullet and replace all 4? Can I get mine rebuilt (do they replace the hoses?) I found injectors reman'd by Standard Motor Products for $35.79 ea on Rockauto - are these any good, or junk? Thanks |
ClayPerrine |
Aug 19 2021, 09:32 PM
Post
#2
|
Life's been good to me so far..... Group: Admin Posts: 15,950 Joined: 11-September 03 From: Hurst, TX. Member No.: 1,143 Region Association: NineFourteenerVille |
For those of you running L-Jet on a 1.8, go to FLAPS and get 4 injectors for a 1980 Datsun 280ZX. Nippondenso built the L-Jet system for Nissan/Datsun under license from Bosch, and the injectors for the Z are mechanically and electrically the same ones used on the 912E. The 912E was L-Jet on a 2.0 914 engine, and the injectors are interchangeable.
Here is some info on them: Beck/Arnley Part Number 158-0099 Used on Alfa Romeo, Fiat, Jaguar, Nissan, Opel, Porsche, Renault, Triumph Hope that helps. Clay |
wonkipop |
Aug 21 2021, 02:56 AM
Post
#3
|
Advanced Member Group: Members Posts: 4,669 Joined: 6-May 20 From: north antarctica Member No.: 24,231 Region Association: NineFourteenerVille |
For those of you running L-Jet on a 1.8, go to FLAPS and get 4 injectors for a 1980 Datsun 280ZX. Nippondenso built the L-Jet system for Nissan/Datsun under license from Bosch, and the injectors for the Z are mechanically and electrically the same ones used on the 912E. The 912E was L-Jet on a 2.0 914 engine, and the injectors are interchangeable. Here is some info on them: Beck/Arnley Part Number 158-0099 Used on Alfa Romeo, Fiat, Jaguar, Nissan, Opel, Porsche, Renault, Triumph Hope that helps. Clay i'm filing this info, thanks. (IMG:style_emoticons/default/beerchug.gif) |
Lo-Fi Version | Time is now: 22nd December 2024 - 10:09 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |