 Rear trunk lid torsion bar installation |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| partwerks |
 Oct 1 2021, 07:12 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,599 Joined: 7-September 06 From: Grand Island, NE Member No.: 6,787  |
My mechanic forgot to put the rear trunk lid torsion bars in before installing the engine.
There is clearance that runs along the back side with this setup. If I remember correctly, Renegade told me they would fit with no clearance issues. Anyway, the thing I'm wondering if I will be able to put them in after the fact?? What is the technique in putting them in?    |
   |
 
|
  |
Replies
| rgalla9146 |
Oct 2 2021, 06:23 PM
Post
#2
|
|
Advanced Member Group: Members Posts: 4,673 Joined: 23-November 05 From: Paramus NJ Member No.: 5,176 Region Association: None 
|
Putting the rollers under tension is a known issue.
The OP is asking if it is possible to install the torsion bars in position through the loop on the back wall of the engine compartment. I don't know if it can be done with a standard 4cyl or 6cyl engine. Anyone ? With a small block ? could be easier or harder..... I'd start by putting the short arm of each bar through the center loop and feed it toward the opposite side of the car. Give it a try. See what happens |
|
|
|
Posts in this topic
partwerks Rear trunk lid torsion bar installation Oct 1 2021, 07:12 PM
914Mels There is a plastic wheel that the bar rolls agains... Oct 1 2021, 08:51 PM 914Mels Here is a picture of the wheel/ roller part #2 Oct 1 2021, 08:55 PM
partwerks
Here is a picture of the wheel/ roller part #2
... Oct 1 2021, 09:33 PM 914Mels Not really, once you get them in the engine compar... Oct 1 2021, 09:43 PM 914e 914 rubber sells a tool. Oct 1 2021, 10:32 PM Arno914 There is enomous tension on those springs. Don´t ... Oct 2 2021, 01:01 AM euro911 https://914rubber.com/rear-trunk-spring-pre...-rel... Oct 2 2021, 07:23 AM partwerks Got the torsion bars in.
Have about an inch of cl... Oct 2 2021, 07:29 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 7th January 2025 - 12:13 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.