Idle Speed and Air Temp/Humidity Options

[StarBear]

As getting ready for the 2022 Northeast Gathering, I'm encountering a semi-recurring idle issue on my 1974 1.8L LJet FI. When outside air is cool and dry, idles just fine at 950-1000 rpm. When outside air is warm and humid, after warmup the idle falls off to barely running. I've just been adjusting the air flow screw (maybe 1.5-2 full turns) to open it. Of course, the reverse happens - if I preadjust the screw it idles near 1800 then settles down to 1100 after the engine gets totally warm (15 mins or so).
I presume (?) there SHOULD be some regulation, perhaps with the ECU or AFM, to monitor air temp and humidity and make adjustments automatically? I didn't have to manually do this adjustment in the past.
The AAR works and tests out fine. Just annoying to have to pull over after running a while and adjust the screw. (IMG:style_emoticons/default/dry.gif)
Your thoughts @Van @Van_B and @Wonkipop ?

[Van B]

Check it all the same.

But, it seems to me that you need to set idle for hot and humid.

With my new AAR, the heated wire alone is not enough to completely close the AAR in cold conditions. The cold engine bay sucks the heat right out of the aluminum housing. But after I drive a while, everything is warm enough that the AAR closes up completely.

I’m thinking you had your idle set for a season and engine bay temp when the AAR was open just a fraction.