How to inspect the underside and longs without a lift, now the Not another novice project thread Options

[seanpaulmc]

I've just purchased a '73 914 and owned it long enough to ship it to Orlando and take it to go get titled. With only having it for this short period my list of concerns is growing. I have no intentions of driving the car around until I can assess how rusty it is. I appreciate the support and responses to the questions about transportation and engine identification. This is a superb community.

What advice do you have for lifting the car to inspect underneath and such without having access to a lift? I have read some of the build threads on here and you guys have some amazing shops and do incredible work! ...one day. But, at this point I don't have that.

For now I'd like to lift the car, take the wheels off, and take the longitudinal covers off to get a good look at the structural areas of the car. However, I have concerns because this is a snowbelt car and I've read the stories about putting a floor jack through a rusted out car. Where should I lift with the floor jack (trust the jacking points?, other areas) and where should I put the jack stands so that I can poke around some and get pictures?

Merry Christmas!!!

[seanpaulmc]

Now that I've cut my teeth on the Hell hole repair, firewall patch, and both jack points it was time to move onto the passenger floor. Here's what I'm working with...









Passenger side floor cross brace has been replaced with keeping most of the old floor in place in order to get set right. Worked out well.





Ah nuts! They were very dirty tenants.









The floor was solid on the tunnel side but no so much on the side of the long. It all had to go.